Electronics Forum | Wed Sep 04 20:29:56 EDT 2013 | saibot
We had that problem a few months ago with one of ours. Had to replace both y-axis motors and the tech said it's a common problem with the Opal-XII.
Electronics Forum | Wed Sep 04 11:37:30 EDT 2013 | trice1212
Afternoon SMTnet forum users, The Assembleon Opal-XII we use has been showing an error when ran at 100% speed. We talked to the tech in AZ and he believes we have a problem with our y-motors. We turned the speed down and haven't had the problem com
Electronics Forum | Fri Feb 15 15:09:24 EST 2008 | soudomphong
Anybody have any idea where to get the cutter motor for siplace 80-S20 with reasonable price? I am also looking for S20 head board, and a Y-axis motor. Any help would be much appreciated, thank you.
Electronics Forum | Wed Aug 24 09:20:25 EDT 2016 | dekhead
Suspect comms link error from Y3 to Y1 crate. COM 2 off of CPU, depending on board. If CPU board has RS485 port it is direct to back panel of PC; if older board it only has RS232 and thus requires 232/485 converter board (internal to PC). then direct
Electronics Forum | Fri Jan 06 09:39:35 EST 2023 | micropak
In newer machines, after changing a motor you have to do an "Axis Home Calibration". Once I changed Z-Axis belt on an SM-482 and it refused to successfully do "Axis Home Calibration. Then the solution was to remove the belt, rotate the motor pulley a
Electronics Forum | Thu Jan 19 07:43:54 EST 2023 | bukas
there is a special tool(cable) used to phase the motor with driver.
Electronics Forum | Tue Jan 17 12:00:14 EST 2023 | dbrenkus
I sent a link to the manual in an email.
Electronics Forum | Tue Jan 17 12:17:04 EST 2023 | eurolan
I appreciate it, thanks for your help!
Electronics Forum | Tue Feb 20 02:35:21 EST 2024 | erikfriesen
If possible, I'd like that service manual, thanks.
Electronics Forum | Thu Feb 22 08:27:32 EST 2024 | micropak
May I request the Service Manual ?
