Electronics Forum | Mon Dec 22 04:55:41 EST 2014 | bobpan
Swap the amps but first manually check by hand to make sure the z-axis is free to move up and down. Sometimes a part can get stuck in the gears. Good Luck
Electronics Forum | Wed Sep 04 20:29:56 EDT 2013 | saibot
We had that problem a few months ago with one of ours. Had to replace both y-axis motors and the tech said it's a common problem with the Opal-XII.
Electronics Forum | Wed Sep 04 11:37:30 EDT 2013 | trice1212
Afternoon SMTnet forum users, The Assembleon Opal-XII we use has been showing an error when ran at 100% speed. We talked to the tech in AZ and he believes we have a problem with our y-motors. We turned the speed down and haven't had the problem com
Electronics Forum | Fri Feb 04 01:31:44 EST 2011 | fujiphil
Possible cause is the Middle Loading Sensor. Check the ML flag. Also, this problem occurs when the z-axis base slips. Need to level the base and re-calibrate z-axis origin.
Electronics Forum | Tue Feb 01 13:21:34 EST 2011 | cyber_wolf
Try switching to a different board and see if the error goes away. If it does, it has something to do with one of the loader sensors not being made.
Electronics Forum | Sat Jan 29 12:01:32 EST 2011 | jts142
hi i am having problems with a cp 643 when i run in auto it errors unloading a board with the x axis servo interlock error but if i hit sequence end stop so that it stops after every board it runs and unloads perfectly. Any hints or suggestions we ha
Electronics Forum | Thu Jan 20 06:01:23 EST 2005 | mhe
Hi guys, we are facing a problem - d axis servo overflow in our fuji cp-4. Can anyone please suggest some remedy? thanks deepak
Electronics Forum | Tue Mar 02 17:41:04 EST 2021 | astarotf
The heads in the middle of production stop and this error appears. We already checked the readers, linear encoders and changed the UIMC cards and found no errors, apparently all these revised parts are working. Can anyone help us where else can we c
Electronics Forum | Wed Mar 03 14:25:02 EST 2021 | astarotf
Hi Spoiltforchoice Thanks for the comment. With the line encoder readers that the machine brings, we performed a positioning reading check, which showed us the increase or decrease in the path that the heads make, with which we conclude that it is re
Electronics Forum | Wed Mar 03 10:14:45 EST 2021 | spoiltforchoice
I don't have one of these machines, but what kind of checks are you able to do on the linear encoders? On our Essemtec there is a dedicated diagnostic utility that gives you a plot of the encoder readout showing both the raw readout as a sort of roun
winsouce.jpg)