Electronics Forum | Wed Mar 16 17:43:33 EST 2005 | pmd
We grease acording to PM schedule. The cable is very old about 5 years. We run 2 shifts. The transducer program and burnin test show the varance that we are seeing phisically so I can rule out the transducer. The motor may be the cause as it is of 19
Electronics Forum | Mon Sep 16 04:11:57 EDT 2019 | richgreen01
Hi, Theta unstable, it picks the part but doesn't rotate it. Regards Richard
Electronics Forum | Tue Sep 10 05:39:04 EDT 2019 | richgreen01
Hi all. I have put.an ic on the y wagon and done first.and last component. The machime picked up the part while testing the package but it didnt center the part ,just sat there for a while and failed. Any idea why this is and am I missing something?
Electronics Forum | Wed Sep 11 11:28:10 EDT 2019 | cyber_wolf
What is the error message ?
Electronics Forum | Thu Sep 12 16:37:26 EDT 2019 | emeto
If we assume Mycronic equipment, you have some erroe in your tray creation.
Electronics Forum | Tue Oct 01 09:45:52 EDT 2019 | cyber_wolf
On some of the older models you cannot have all of the other accelerations turned up and theta set to slow. Bump up the theta speed.
Electronics Forum | Thu Jul 23 03:15:43 EDT 2015 | padawanlinuxero
So let me get this straight you want the mydata to pick the SOT-23 from the reel tape take it to a part of the y-wagon put the SOT-23 inside the programmer, program the sot-23 have the midas (which is the only one can do something similar) pick up th
Electronics Forum | Thu Jul 23 09:15:18 EDT 2015 | padawanlinuxero
mmmmm.... what type of y wagon you have on the mydata?
Electronics Forum | Wed May 09 17:49:16 EDT 2012 | dyoungquist
We run a Mydata high mix, low volume line. You can handle strips with either the Agilis feeders (losing the first 5-10 parts) or by placing the strip on the Y or tray wagons. For cheap parts like resistors, capacitors, some diodes and small ICs, ou
Electronics Forum | Tue Aug 31 19:44:25 EDT 1999 | dean
| Do any SMTneters out there have a good solution to substitute SMT parts that you are willing to share? I presume all of us have the issue where purchasing wants to buy "the same part" from a different vendor. While the part may be the same electric
winsouce.jpg)
