Electronics Forum | Wed May 08 10:21:05 EDT 2019 | compit
During the start the error "DOWNLOAD VISION ERROR" - instead of "OK" is "NG". - resolved - video card died. But I still have a motor overload error Y1 (L057:CUR.DEV ... Y1 error) - what resistanc
Electronics Forum | Thu May 20 16:14:55 EDT 2004 | jsk
UP AND RUNNING!!! Power supply is good but i found two loose wires in connector 12PL26 (DC to Y1). I think i may have another bad connection inside the Y1 enclosure. Monitor seems to be working OK. Thanks for your help, jsk
Electronics Forum | Thu Jan 21 15:36:37 EST 2016 | brantco
I have the Error message E00900 i have checked the troubleshoot and it says to check SP1 XP6 and Y1 i have checked SP1 its ok, Relay XP6 seems ok Y1 i dont know where it is located here is the error "Air Pressure Fault" any help would be greatly
Electronics Forum | Fri Jun 30 08:16:28 EDT 2023 | gfe
Hello Bob, yes it was the Y1 that broke down, it was replaced by another machine, thank you.
Electronics Forum | Tue Jul 31 22:32:35 EDT 2018 | dekhead
Hardware dongle on back of machine is software key which may or may not be required for your software (depends on software version) and has nothing to do with the error you are experiencing. The hardware link to which I refer is on the Y1 backplane
Electronics Forum | Wed Aug 24 09:20:25 EDT 2016 | dekhead
Suspect comms link error from Y3 to Y1 crate. COM 2 off of CPU, depending on board. If CPU board has RS485 port it is direct to back panel of PC; if older board it only has RS232 and thus requires 232/485 converter board (internal to PC). then direct
Electronics Forum | Tue Jun 27 05:28:32 EDT 2023 | ttheis
We powered up our Advantis machine after leaving off for several months. When we powered it up went to zero it we get an error on the y1 axis during zeroing. Command move home: pattern step 0. The y negative limit is hit during homing, the axis then
Electronics Forum | Tue Sep 01 15:18:04 EDT 2009 | babe7362000
Is there anyone out there that can help me with a Y1 axis failure on a Meridian 1030? It seems to be an intermittant problem but is now getting worse. Please let me know if you can help
Electronics Forum | Sat Feb 20 20:45:53 EST 2010 | dekhead
Sounds like you have a Switched 12V issue. Breaker on rear of Machine. Fuse in Y1 enclosure. PSU3 (on floor of) Y4 enclosure.
Electronics Forum | Mon Nov 19 05:16:02 EST 2012 | ericrr
Thank you ENIAC for your comments Here is another problem (JUKI KE-750L) Which applies to 0603 (1608 metric) resistors and only resistors (mind you the board is more heavily populated with resistors) After the panel has gone through the oven, Wh
