Electronics Forum | Fri Apr 28 16:03:31 EDT 2017 | ilavu
I have GSM1 (OS/2) machine and it does not zero. The Y axis comes to all the way front to hard stop. I replaced the limit switch before the hard stop and can not find any way to test the signal from limit switch in diagnostic. I like to replace the c
Electronics Forum | Sat Jan 26 15:47:10 EST 2019 | dfl
I'm with an annoying problem with an IV-c. Almost all the time the Y-axis "stuck" when the machine is homing. The motor tries to move the axis but only make a sound. If I move the axis by hand it can complete the homing and then goes to the IDLE. So
Electronics Forum | Mon Oct 31 09:31:30 EST 2005 | meritajs
Thank all for help Good luck
Electronics Forum | Thu Jul 09 13:13:01 EDT 2015 | horchak
Is the y axis sitting on the out of limit switch by chance
Electronics Forum | Wed Jan 30 17:38:32 EST 2019 | bobpan
try at 2 good luck
Electronics Forum | Fri May 10 11:23:21 EDT 2019 | sumitsingh
Are X & Y axis motors affected because they may "climb" or "Moves down" as machine is not leveled up?
Electronics Forum | Thu Apr 28 05:52:21 EDT 2022 | sophyluo1985
Please send the error message to my email quinnsmt@gmail.com
Electronics Forum | Sun Jan 27 17:59:25 EST 2019 | bobpan
The y-axis on that machine is left to right. If this is the axis you are having a problem with....check the motor. I have had to tighten the tension on it before. If you notice you lose steps after running for a while then this is going to be the iss
Electronics Forum | Wed Oct 26 03:43:11 EDT 2005 | meritajs
Hi Ken, Thank for your advice We suppose that with home position all is OK and ratio is in interval 40-60%.Y axis offset is not constant 5mm or 10mm but change ratio with working time and may be more than 10mm We think that problem is with Yservo mo
Electronics Forum | Thu Oct 27 03:15:14 EDT 2005 | Jeff Roberts
The Y-axis motor of the YM84 Series is well known for failures. The bearing between the encoder and the armature fails causing dirt to fall on the encoder wheel, hence the encoder mis-counts. If you re-Origin the machine the problem is resolved for a