Electronics Forum | Wed Jul 03 08:10:34 EDT 2019 | bobpan
The amp is mounted on the back side and is black. 4 total mounted for x and y axis.....swap the 2 that are y axis amps. If you have never servo tuned before on a quad machine you not going to be able to do it. There is way to many things that you nee
Electronics Forum | Thu Apr 28 03:58:52 EDT 2022 | erici
We are having problems with our Siemens Siplace S27 machine. The machine is giving the error - Y-axis Faulty initialization of Motor. We replaced the Y motor card and swapped also the servo control cards on the two gantries. Still will not initiali
Electronics Forum | Sun Sep 15 04:45:22 EDT 2013 | jandon
Cleaning and lubrication requires maintenance training. You can really break something if you don't know what you are doing. For example you can break your expensive rubber nozzles or cameras with inappropriate cleaning. Check: - Piping and joint -
Electronics Forum | Fri Sep 22 13:03:26 EDT 2006 | daxman
I ran the vision test...here is what I got. Camera System: Completed Repeatability VX mean = -3.177942 Standard Deviation = .000059 VY mean = -12.114077 Standard Deviation = .000065 Vision System: Completed Repeatabi
Electronics Forum | Wed Mar 19 15:59:40 EDT 2008 | rmitchell
Hi, I am having some problems with my CP6 placement changing in the Y axis. I had to move all parts by +.12mm this morning. Then after 20 boards the placement shifted too high by about .12 mm The IP stayed the same with the same pcb's and fid coo
Electronics Forum | Thu May 05 11:11:20 EDT 2011 | jimlas53
OK, understood. In the case of SO14, I have some in vibe feeders and some in tape. The tape parts, when I set the extent up, would be picked at 0 Theta, because the part length is parallel to the Y axis. The vibe parts, which are perpendicular to
Electronics Forum | Sat May 14 12:28:49 EDT 2016 | dilogic
Any ideas that can cause y-axis resonance? I ruled out all usual the suspects (tacho sensor, driver cards, motor driver etc.). Looks like some mechanical issue, but can't figure it out. I suspect leadscrew nut - I checked it with motion diagnostics s
Electronics Forum | Mon Sep 14 16:36:40 EDT 2015 | simons
Upon start up our QSA machine is giving us the following errors. Cant reset motor alarm (x axis) Cant reset motor alarm (y axis) Cant reset motor alarm (z axis) What are the possible reasons for this? Thanks
Electronics Forum | Wed Jul 03 07:49:35 EDT 2019 | daniel_marquette
Got it. Servo tuning is new to us, so we'll try it. When you propose to swap the Y axis amps, do you refer to the driver that controls the Y motors? Thanks,
Electronics Forum | Tue Nov 11 18:41:21 EST 2003 | mantis
Hey all, Anybody out there able to shed some light on the above error.My Mpav powers up with this error and wont let me do anything the manual is not much help either. Regards, Mantis
