Electronics Forum | Wed Sep 13 17:14:09 EDT 2023 | brantco
Hello Everyone i have a ESS-310 and have to input a negative number on the Y axis would anyone know the button combination for a negative number
Electronics Forum | Wed Jun 28 22:42:34 EDT 2023 | unsung
I work on a few of these Universal machines before. Check your severos ( I believe their 6 of them ) in the back of the machines all of them should be on. If you see a red light on one of them it's gone bad and that's your Y axis card. It's easy to
Electronics Forum | Fri Aug 11 11:18:20 EDT 2006 | chrisgriffin
I got a 3000 that is acting crazy. After a print, the board is unclamped and the Z-axis lowers. It continues to lower until it trips the limit switch. It is suppposed to move in the Y-axis to line up with the tracks while lowering in the Z-axis.
Electronics Forum | Tue May 10 09:45:53 EDT 2011 | veeckm
After changing mod codes 50,51 and 54,55 respectively on the HHT I will then goto ccconfig.sys file in the central controller software and manually enter in the new mod code values. I do not do any uploading/downloading of mod codes through database
Electronics Forum | Wed Jul 08 10:29:14 EDT 2015 | goodting
Dear SMT Specialists Had anyone encountered GSM ADvantis zeroing failure problem? The x-axis is idle while the y-axis is waiting to be activated. My initial guess is either Axis control board or machine configuration conflicts. How to fix it? any le
Electronics Forum | Wed Feb 04 23:27:38 EST 2004 | dougt
I did some work with 400E's and have can give you a couple things to try with your Y axis problem. 1. There is a file called stepperparms.exe that will load all the stepper parameters on the PCL IC's. Your y axix chip may have corrupt data on it.
Electronics Forum | Fri Aug 11 17:21:43 EDT 2000 | Dave F
John: Sorry I'm tardy getting back to you on this Heat capacity = [applied voltage in volts*applied current in amps*(time ending in seconds - time start in seconds)]/(�K ending - �K start) The units of heat capacity are joules per mole-degree when
Electronics Forum | Fri Sep 24 14:05:06 EDT 2004 | jsloot
Is there anyone using a QUAD QSA-30? I am experiencing problems with the Y axis drifting in the positive direction. This can occur anytime from a few minutes to several hours after the problem has been fixed. Fixed means recreating a program from scr
Electronics Forum | Tue Oct 25 22:50:16 EDT 2005 | KEN
What is the (initial position) ratio of pulse counts to home encoder pulse (relative to the home sensor). It should be 50% +/- 15% Run this test several times in between a warm up. I bet your numbers are all over the place. I bet you have a loos
Electronics Forum | Wed Oct 26 21:44:42 EDT 2005 | KEN
If your sure your drive lines are staying put then it must be the motor. ... odd no servo feedback alarms though. That's why I thought problem might be mechanical. Does the yv84 use servo's? IF yes, then no brushes to wrory about. Don't bother t
.jpg)