Electronics Forum | Fri Mar 02 15:01:32 EST 2007 | dyoungquist
We have a TP9 and are having no problems placing 0402s or fine pitch QFPs. Try slowing down the accelerations on the X and Y axis. That increases the time it takes to place a part but I have found that it can help accuracy. All the other posts hav
Electronics Forum | Wed Aug 02 14:54:15 EDT 2006 | chrisgriffin
I mean if you are using the same stencil for the top and bottom of a board. Thanks to everyone for the help. From what I gather, it will work when the stencil cut-outs are offset from center in the Y-axis. Doesn't work too good in the x-axis, beca
Electronics Forum | Fri Feb 23 08:53:52 EST 2007 | russ
Ours does not have a vacuum option so that may be it, the machine came with an assortment of standoffs and support plates as well. it is not drilled out in a grid but does have the center tapped which I assume is for the vacuum tooling. Ours has a
Electronics Forum | Mon Aug 13 14:11:14 EDT 2007 | jeffharley
Slot 11 in the I/O box is the one for B.E.C. pcb, the offset is 2125 in the x and 500 in the y axis. The template for the B.E.C. is triangle in shape and is the length from corner to corner on the rotary table. You can also type in sh sys and look to
Electronics Forum | Thu May 21 20:25:26 EDT 2009 | voytek
I had to replace two Y-axis servo amplifiers on our GSM1 machine. I'm sitting on two faulty servos that I would like to have repaired. Let me know if you now place which specializes in repair of Servo Amplifiers Mod. No. 800-444 by Copley Controls.
Electronics Forum | Wed Aug 05 14:20:21 EDT 2009 | jorge_quijano
Hello there, I'm having some problems w/MPM up2000, Vision Y axis software limit error, when I tried to create a new program, appears the "Value out of range for VY BSS POS, spec 0.00 min -26.5, read 8.45" message. Any idea of how to correct this pro
Electronics Forum | Sat Aug 21 15:02:32 EDT 2010 | jry74
I have a pcb with 750 plated through holes that get Holtite sockets inserted into them. I have a method of pressing in 10 sockets at a time. However, when we are done, the board has bad warpage on the X and Y axis. Does anyone out there have any t
Electronics Forum | Sun Jun 07 19:16:54 EDT 2015 | linux
Hello everyone, I'm looking for help with placement issue on our cp6 Fuji. On occasion we have to adjust co ordinates on the x and y axis usually about 0.12mm. Ball screw was replaced did not fix issue. Anything else we could try. Thanks everyone
Electronics Forum | Thu Jun 02 15:16:54 EDT 2016 | dilogic
I did try to null the axis - no improvement. I have AMC software and tried (almost) everything related to electronics (except for changing linear encoders, but this seems to be OK - when I move axis manually, position numbers change smoothly). It loo
Electronics Forum | Fri Apr 28 02:10:19 EDT 2017 | bukas
i'd say its a ball nut. maybe it came loose or the balls are worn out. also, check timing belt! if resonance is periodical like you say then there is great probability that belt or/and belt pulleys got worn out. i had combination of these on one of m
