Electronics Forum | Wed Feb 08 01:30:02 EST 2017 | nikkilouie
Im having trouble with and Ekra x5 machine. It > works fine when up being run constantly, but if > it sits for 10-15 minutes when you try to move > the Y table to the front of the machine it makes > a loud sound as if the table is hitting/catchin
Electronics Forum | Fri May 20 12:14:25 EDT 2016 | strandy89
Im having trouble with and Ekra x5 machine. It works fine when up being run constantly, but if it sits for 10-15 minutes when you try to move the Y table to the front of the machine it makes a loud sound as if the table is hitting/catching on somethi
Electronics Forum | Thu Aug 22 04:08:17 EDT 2002 | Jason Baldwin
Symptom: Board Stuck on Print Conveyor error messages. Cause: Board not flagging the camera sensor. Remedy: Check the following items: � Check the camera sensor can see the board underneath. � Check the camera sensor calibration (in Tools, Camera Re
Electronics Forum | Mon Jul 30 10:22:57 EDT 2007 | swag
Sounds like your board stop sensor is not working properly so it's not seeing the y-stop/board edge when the board enters the center or the machine. You could try taking the camera cube cover off, jog the camera over a board then move the board back
Electronics Forum | Tue Sep 29 10:10:34 EDT 2015 | swag
We used to have a UP3000. Long time ago so I'm rusty but isn't there a setting for fid correction that you an program to occur after each board or after 5, 10, etc.? I thought I remembered doing offsets on ours as the camera was a little wacky (old
| 1 |
.gif)
