Electronics Forum | Mon Sep 10 17:52:30 EDT 2001 | mparker
Are you doing actual measurements of the dummy parts placements? or are you just doing a visual go/no go check? If doing actual measurements, be sure to use mil inch units of measure rather than mm. Mil will give you more accurate readings. mm force
Electronics Forum | Mon Nov 27 18:50:48 EST 2006 | darby
G'day Marina, Only YM/CSM seies feeders will fit these machines. Feeders were generally prefixed as Y8, Y12 = mechanical advance 8mm, 12mm. There may be some Y16 in existence but I doubt it. HA12, HA16 = air activated 12mm, 16mm. The HA12 could take
Electronics Forum | Tue May 01 13:52:51 EDT 2007 | jasont
plz advise if the below feeders are compatible on CSM 46/60 (are they downwards compatible?); 1. Philips series FV-84-xxxxxC, model PA2903/70 (2,4 pitch, 8mm) QTY=29 2. Philips series FV-82-7-xxxxD, model PA2903/73 0603-type (2,4 pitch, 8mm
| 1 |
