Electronics Forum | Mon Sep 29 15:28:29 EDT 2014 | dustin
After getting the last issue I had fixed through here. I thought I would try to see if there is a solution for another issue. I have and ekra e5 screen printer and it has a problem with the blades not dropping when they should. If I set up single dir
Electronics Forum | Mon Feb 25 08:14:04 EST 2008 | adetuc
Hi ... We use DRS24C Air-Vac machines for placing BGA devices, and have been having problems with shorts on corners of one device in particular, its a PBGA and its size is 4.5cm square and 15grams weight. When the component is picked up and the com
Electronics Forum | Tue Sep 26 14:06:33 EDT 2006 | patrickbruneel
Jun 26, 2006 (See Comments Below) Editorial Managing the Naughty Child Mike Martel, Editor, Circuitnet I've been listening to voices on both sides of the RoHS issue and the more I hear, the more foreboding the tone becomes. Despite what some wr
Electronics Forum | Sun Aug 06 19:05:38 EDT 2017 | zsoden
OK thanks. I had assumed that since the soldering was generally smooth and we were having no issues with bridges that the flux would be operating fine. But there really isn't much left to check so I'll get my profiler fixed (the thermocouple has been
Electronics Forum | Tue Apr 27 13:33:29 EDT 1999 | JohnW
| Has anybody had experience wavesoldering 1 watt 2512 resistor packages?? I know it can be done, but are there reliability issues? | | We are in the middle of a new product and the question was posed to me "Can we use 2512 1 watt resistors on the
Electronics Forum | Mon Jul 31 20:34:58 EDT 2017 | zsoden
Hi all, it has been a bit of a delay but I've finally had a chance to do some further investigation on this. First off, we spend some time to clean the solder bath using Kester Solder Saver and scooped out a lot of crap. We then added about 5kg of
Electronics Forum | Sun May 21 23:29:38 EDT 2017 | zsoden
Hi all, We run an old Seho 1135C wave solder with a 63/37 pot at 250°C. It has been running well for a couple of years but we have noticed lately that all of the larger pads (terminal blocks, transformers, etc.) require additional solder to be appli
Electronics Forum | Tue Apr 27 16:44:05 EDT 1999 | Chrys Shea
| | Has anybody had experience wavesoldering 1 watt 2512 resistor packages?? I know it can be done, but are there reliability issues? | | | | We are in the middle of a new product and the question was posed to me "Can we use 2512 1 watt resistors o
Electronics Forum | Mon Oct 12 08:07:45 EDT 1998 | Earl Moon
| I have datas to substain that a not wetting PCB ( the HAL oxided or not uniform in thickness )if soldered in reflow, it shows voids with X-Ray inspection.The voids are in side all the joints not only on the solder pads levell. | | Is there a techn
Electronics Forum | Wed Feb 20 17:53:02 EST 2002 | djarvis
I certainly fit both citeria - 6'4" with a face like a bashed crab. I think I'm the one on the far right in white in the top picture at http://www.delicate.com/audio.htm which I believe is us at Mudd Island, Memphis in 1983. Alisa and Steve - now I
