Electronics Forum | Wed Jun 18 02:43:37 EDT 2014 | tjbooc
CHECK IO BOARDS STATUS, CHECK HEAD IO 24VDC SUPPLY, CHECK 24VDC SUPPLY TERMINAL, CHECK WIRING CONNECTED TO HEAD IO I think this is an I/O communication problem. Fail in connecting to I/O cards.
Electronics Forum | Mon Sep 20 00:51:03 EDT 2010 | jeffr
This particular Yamaha Head I/O Board is a common failure. Yamaha supply an updated version which is less likely to fail. The cause of the problem that you see is due to the connectors on the flexing and damaging the inner layers of the board. The on
Electronics Forum | Wed May 02 22:14:21 EDT 2007 | DSD
The Philips Orion (Yamaha YV100) Head I/O Board is usually at fault as this tends to suffer trackwork problems with age due to the constant flexing of the board stressing the connectors on the board, thus breaking tracks within layers. You should not
Electronics Forum | Tue Sep 01 11:12:18 EDT 2015 | zombee
Problem is solved! There wasn't voltage on motor inputs (only 5-10V AC) when the motor connected correctly, but was ~210V AC without motor. Firstly, I exchanged the motor speed control relay (Panasonic G-series type), but the result was same. (the a
Electronics Forum | Tue Jun 17 10:46:16 EDT 2014 | bestglobalsmt
When the machine loads up it gets to the 2nd to last step where it starts to load vacuum data - we get 4 pop up windows once that fails. Ea2510 Machine Start error - Machine cannot be started Es00212 APPL CPU Haandshake error Ea2504 I/O Data trans
1 |