Electronics Forum | Fri Aug 25 11:00:37 EDT 2006 | SWAG
Thanks for the advice. This is not a Universal camera. I removed the lense from a "blown" camera and installed a new CCD that I bought from a camera shop. I only see one ring that can be adjusted on the camera itself. Not sure if it's aperture or
Electronics Forum | Thu Oct 16 04:46:46 EDT 2014 | haiae
I'm looking for a new or used servo motor for my Yamaha YG100R PnP machine with original model: Q2GA04006VXS2C (Sanyo denki ) If anyone can offer it please contact me ASAP. Thanks & best regards,
Electronics Forum | Thu Oct 21 06:26:50 EDT 2004 | dennispoquiz
Right. Fiducial comes with the CAD data or the gerber files. If it doesnt, and you need to create fiducial coordinates, you may use a digitizer or a caliper and make use of the reference pin as the origin. Now if the fiducial camera focus is way out,
Electronics Forum | Tue Apr 27 16:42:18 EDT 2010 | m79d
Hi jepoy + a very frazzled man thanks for your suggestions,here is how it went:- I found a couple of these VM1710 boards and tried one and still nothing. I really wanted to see if power was getting to the camera and anything coming out. I was loo
Electronics Forum | Sat Mar 31 11:03:21 EDT 2007 | jmelson
I have a left to right conveyor, so the X offset is larger, but that is not major. You say "Make sure you are teaching with the unit that the machine defaults to or asks for." This is the beam sensor, and I have found no way to change this, either
Electronics Forum | Fri Dec 09 17:57:16 EST 2005 | mika
cameras > P2P (Part to Pad looking camera or upper looking camera) > front or rear >> select the corresponding camera that You have installed. After that: just save and follow the instructions on the screeen. By the way, an important thing is: You M
Electronics Forum | Fri Apr 06 02:17:15 EDT 2018 | rob
@ Sr.Tech, Most of our Chinese spares are Juki & Yamaha original & still bagged, just much cheaper. They wouldn't sell machines in China if all the spares and consumables were at European mark ups. Nozzle wise the Juki 750 & 760 copies are not 100%
Electronics Forum | Sun Jun 17 09:37:41 EDT 2018 | sarason
The trick is to have the correct socket to place the IC into. Have the board permanently on the machine , place your IC run the attached programmer. pick up the IC and place back in the original or a new tray. Most SMT machines would be difficult to
Electronics Forum | Sat Nov 26 00:02:17 EST 2011 | kevintough
I agree with this post about new and standard component names. Standard components should not be changed outside of perhaps widening the tolerance to accept poorly produced components. By purchasing poor quality/cheep components your purchasing depar
Electronics Forum | Thu Jul 07 19:39:18 EDT 2005 | darby
This is a very difficult question to answer as it will depend greatly on your component mix. I will presume that the CSM 84VZ is of the following configuration: 2 x RDC Synchro Heads. Heads 1 & 2. These are mechanically centering heads with a chucki
.gif)
winsouce.jpg)