Electronics Forum | Fri Aug 17 17:23:21 EDT 2012 | processman
Hi, Looking for some experience from others regarding frequency of repair, maintenance etc on UIC Lightning Head spindles. We have a genesis machine for the last year and we are continually removing and repairing spindles due to the Vaccuum or b
Electronics Forum | Fri Dec 16 10:57:38 EST 2022 | sarason
In the automotive industry there has been a swing away from gaskets and a movement to high temp resistant sealing compounds. In all probability your original gasket would have been viton for high temp O-rings. So if that is the case the replacement
Electronics Forum | Wed Mar 08 16:52:07 EST 2006 | darby
Which model Yamhah are you talking about and what is the make and model # of the manifold block for the micro ejectors? If it has the Koganei ME05M series then your local rep can supply the filters. It is a good idea to get spare O-rings for the filt
Electronics Forum | Wed Sep 16 10:35:45 EDT 1998 | John McMasters
| | Has anyone used Fuji's rubber tip nozzles for the IP3? Are they O-ring type or suction cup? I'm having trouble picking up Ompacs due to the top of the part not consistently being flat. Any actual experience with these $1100 nozzles would be app
Electronics Forum | Fri Sep 20 19:06:09 EDT 2002 | mjabure
The way it works is the first index is done with the feed cylinder, and the final is done using the cam during pick. You might want to check to make sure you're getting a full, complete stroke out of your feed cylinder, also make sure the mechanism
Electronics Forum | Tue May 18 09:58:17 EDT 2021 | kumarb
Thank you so much for the advice. We were suspecting blockage but know that we have clean nozzles. Did the air blow out and removed a spot of black matter - perhaps what was an old o-ring? Nozzles are 61 and 62 posing the issue. Our tech said that 64
Electronics Forum | Wed Jun 24 14:42:03 EDT 2020 | kumarb
Hi. Heck no! First, you should find out the Yamaha equivalent of your machine, if known - that is a more common reference when sourcing parts. While we have no affiliation with the vendor other than a very positive history of sourcing a laundry list
Electronics Forum | Tue Sep 07 15:28:13 EDT 1999 | Earl Moon
Listed below are the issues Viking has been experiencing since the installation of the Proflow Head: 1. After installing new 350mm Wiper foil with metal strip glued on it, It worked for about a week and suddenly metal stri
Electronics Forum | Wed Sep 08 08:25:26 EDT 1999 | Brad Kendall
Listed below are the issues Viking has been experiencing since the | installation of the Proflow Head: | 1. After installing new 350mm Wiper foil with metal | strip glued on it, It worked for about a week and suddenly meta
Electronics Forum | Wed Sep 16 16:03:36 EDT 1998 | Ben Salisbury
| | | Has anyone used Fuji's rubber tip nozzles for the IP3? Are they O-ring type or suction cup? I'm having trouble picking up Ompacs due to the top of the part not consistently being flat. Any actual experience with these $1100 nozzles would be a
