Electronics Forum | Thu Apr 14 18:28:20 EDT 2005 | darby
We use the standard supports that come with the machine. Print a 1:1 transparency of the first pass side of the pcb including mechanical outline and components. Your customer may need to supply this. Flip this over and tape it into position at th
Electronics Forum | Wed Feb 19 12:47:15 EST 2020 | emeto
Grandpa, You got it - Identifying the bottleneck operation is the key. The secret is to design a tool can predict accurately where this bottleneck is. In your formula you can use machine process time, PCB transportation time, part trim time, part in
Electronics Forum | Thu Feb 22 16:40:23 EST 2007 | mika
One of our customers that always was going for Ni/Au surface finish on RoHS PCB and our processs was adjusted for that, "whithout any problem". Recently they decided to switch to another surface finsh: PbFree HASL. What is that? Imersion tin/silver?
Electronics Forum | Mon Dec 04 13:06:09 EST 2006 | Todd
I work for a small SMT contract manufacturer with a couple SMT lines utilizing both old (IP1, CP3) and newer (CP643, XP242)Fuji machines. We have an issue with an IP1 that has us stumped. One of the device locations has no power. After some basic tro
Electronics Forum | Wed Sep 22 16:48:40 EDT 1999 | C.K.
Question for you SMT guru's out there. What is the best way to support boards on Fuji's CP6 machine's x-y table...particularly for 2nd side SMT where the support side already has parts... I am toying around with the following methods: 1.) Custom b
Electronics Forum | Wed Sep 22 16:51:05 EDT 1999 | C.K.
| Question for you SMT guru's out there. | | What is the best way to support boards on Fuji's CP6 machine's x-y table...particularly for 2nd side SMT where the support side already has parts... I am toying around with the following methods: | | 1.
Electronics Forum | Thu Sep 23 10:20:58 EDT 1999 | Earl Moon
| Question for you SMT guru's out there. | | What is the best way to support boards on Fuji's CP6 machine's x-y table...particularly for 2nd side SMT where the support side already has parts... I am toying around with the following methods: | | 1.
Electronics Forum | Thu Sep 14 19:19:38 EDT 2006 | SWAG
I would try to panelize as big as you can for sure as you'll spend more time handling single boards than running anything. Additionally, this size is very close to smallest capabilities on GSM depending on your configuration. Fids on all boards in
Electronics Forum | Thu Apr 11 11:24:55 EDT 2013 | markhoch
Thank you for your advice Eric. Different SMT Machine Platforms have different methods for handling these PCB Panels with bad circuits. (Commonly known as "X-outs"). Some platforms allow you to identify X-Outs simply by darkening in the first fid
Electronics Forum | Mon Mar 17 11:56:38 EDT 2008 | dyoungquist
We have had VERY GOOD free tech support from Mydata. However, we bought a refurbished TP9 directly from them. I believe if you by a used MyData machine from someone else there is a fee to register your company and the machine in their system before
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
