Electronics Forum | Sun Mar 24 16:53:44 EST 2002 | mikestringer
We place a similar square pin style of connector on one of our products. The connector is a 22mm high HW series from Samtek. We have a Yamaha YVL88 MK1 and YV88XS set up to handle them (Yes they are rebadged as Philips machines in some markets). No
Electronics Forum | Wed Jan 17 11:04:57 EST 2001 | gerits
Dear Kyung Sam Park, If you use Philips E.M.T. or Yamaha equipment you can get this software via them. In case you use other equipment you can go and visit the site of Cimcis company who make software for what you are asking. (www.cimcis.com) Regar
Electronics Forum | Mon Nov 19 02:30:09 EST 2018 | robl
OK, so all GEM Machines & MG were built by Yamaha, and imported in to Europe & USA and other places by Philips. After a while Philips developed it's own machine - the FCM. Philips then sold off it's SMT division and it was rebranded Assembleon.
Electronics Forum | Tue Dec 06 11:14:04 EST 2005 | fastek
Correct Rob. All of those platforms are built by Yamaha in Japan. You cannot buy a Yamaha machine in The US.....must be Philips/Assembleon. Same scenario in Europe? Rick
Electronics Forum | Thu Dec 08 19:38:02 EST 2022 | compit
for old Yamaha / Philips / Assembleon ...
Electronics Forum | Tue Dec 06 04:30:16 EST 2005 | rlackey
I was under the impression that the Assemblion/Philips Opal/topaz/GEM/Comet etc were all built in the same factory as the Yamaha machines - all except the FCM's. For the record they have very good support - better than Yamaha in some regions such as
Electronics Forum | Sat May 03 10:20:47 EDT 2014 | proy
https://groups.yahoo.com/neo/groups/Assembleon-smt/info See above, I have created a yahoogroup for Assembleon, philips, Yamaha users (a while ago I created a yahoogroup for zevatech and have since moved on, but it is still alive with some 75 active
Electronics Forum | Mon Nov 01 02:17:39 EDT 2010 | sarason
I have finally finished my shareware SMT program, It reads Protel and spits out Yamaha/Philips UFOS files. It can be downloaded from: http://users.tpg.com.au/sarason/index.html Andrew
Electronics Forum | Fri Jan 08 04:39:15 EST 2016 | sarason
It does VIOS 1.21. and 1.23 as well as the YP/YG stuff if that Phillips Topaz speaks any of these Assembleon/Philips/Yamaha dialects you are in luck. regards sarason
Electronics Forum | Tue Apr 11 03:05:36 EDT 2017 | robl
Hi Andras, we use Qinyi in China for nozzles and feeders for the YV machines, it's probably worth trying them for the older YM ones. Contact Eric Wu, sales@qy-smt.com
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
3 Road Xintang， Fuhai Street，Fuyong
Shenzhen, 30 China
Phone: 13713862102
