Electronics Forum | Tue Apr 05 03:44:36 EDT 2011 | don7888
Hi Recently I have been set the task of increasing the amount of time our pick and place machines (Mirae MPS-1025P) are running for. I am fairly new to CEM and have found that the main reason the machines are offline for so long is that the operator
Electronics Forum | Wed May 23 08:39:37 EDT 2012 | tony_d
Thomas, We evaluated several AOI machines and narrowed the field to two, YESTech and MIRTEC. We had an opportunity to work with both of these machines on our production floor. In our experience, the MIRTEC machine simply outperformed the competitive
Electronics Forum | Sun Feb 15 09:59:31 EST 2009 | pvasquez
Hello Muarty, This is the age old question on AOI. Fortunately, the answer hasn't changed much over the years. It really depends on your business...period. A high-mix low-to-mid volume manufacturer, will need to concentrate on equipment that may
Electronics Forum | Fri May 27 08:36:26 EDT 2005 | K
Thanks for your replies, to go a little deeper..... The sample run I chose was a very small run.... 3 PCB's, 340 parts in total required for the 3 boards. Machine mischuck info gave a total of 360 parts used, 20 lost to various reasons, recognition/
Electronics Forum | Thu Feb 26 14:47:19 EST 2015 | superlen
unique mnf/mnf part number. - Be meticulous on maintaining your WO Boms. Train your employees to not circumnavigate keeping the WOBOM accurate to what they kitted/placed on the board. If you keep the one to one part number relationship above this is
Electronics Forum | Wed Feb 06 13:45:39 EST 2013 | phase1
Is there alot more to training than what the manuals spec out? The machine came with training outlines that seem to be a condensed form for programming everything from chips to fine pitch etc. Im not sure if this doccument came from Mirtec or the com
Electronics Forum | Thu Dec 21 15:13:16 EST 2017 | georgetruitt
Is the process the same for every product running through the selective solder machine? Load program, acquire or set up fixture, Change/load flux?, Change/Load solder pot? Are the machines cold when the operators need to use them or are the machin
Electronics Forum | Thu Jul 20 13:32:11 EDT 2023 | spoiltforchoice
I doubt either Mycronic or Essemtec, as the only people who do dispense printing, will want to share their research with you. But clearly they will have followed every valid option to determine what is possible. Time & pressure is not used for anythi
Electronics Forum | Wed Nov 02 17:49:07 EST 2005 | grantp
Hi, We used a batch oven from Reddish Electronics out of the UK. It was convection, and ok, but had limitations. Batch convection ovens start to heat up, so the metal of the oven is hotter and hotter and it effects the profile. So we ended up need
Electronics Forum | Fri Nov 04 11:29:46 EST 2005 | JeffP
Jay, I work for a company that manufactures batch reflow ovens however, I will try to be as subjective as possible. For the most part, what others have posted is true. Yes, there is one heating chamber and if the heater does not have enough power
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
