Electronics Forum | Sat Dec 06 06:04:53 EST 2008 | exman
does anyone know where to get yestech aoi manual ?thank you
Electronics Forum | Mon Dec 08 19:54:42 EST 2008 | josh_brubaker
Have you emailed YESTech? http://www.yestechinc.com/Contact.htm#EmailUs
Electronics Forum | Thu Apr 19 18:03:56 EDT 2018 | spikesnpearls
hello i am a new aoi programmer and i was wondering how to choose/change what type of lighting it uses while scanning the board.i use a yestech ytv-fx
Electronics Forum | Thu Oct 04 14:38:00 EDT 2018 | babe7362000
Thanks I will try to calibrate again.
Electronics Forum | Fri Jan 19 08:03:07 EST 2018 | babe7362000
Is anyone Familiar with Yestech B2 Calibration. I can not get the Camera angle to pass. Please message me if you can help me. Thanks
Electronics Forum | Thu Jan 25 07:48:37 EST 2018 | cgreiner
Send me your email and I will send you a calibration procedure that I used to adjust my B2 unit. Best Regards
Electronics Forum | Wed Sep 26 11:14:09 EDT 2018 | babe7362000
Can anyone tell me how to adjust the B2 Brightness? Sometimes it is hard to see the markings, because it is too dark. It has been awhile since I have done this. Thanks for any information.
Electronics Forum | Fri Oct 05 09:03:36 EDT 2018 | dontfeedphils
Yea, probably need a new board, which may be tricky considering how old these models are getting now. I had a B2 at my last shop and we upgraded to a Koh Young Zenith 3D. At the time, Yestech told us the camera in the B2 would go for around 10k jus
Electronics Forum | Wed Jan 31 10:37:10 EST 2018 | dontfeedphils
I believe there are three small allen head bolts that hold the camera card to the gantry. Loosen them a bit and ever so slightly move the card up or down depending on the angle.
Electronics Forum | Thu Sep 27 10:13:31 EDT 2018 | dontfeedphils
This should help out. You should have a fairly large calibration plate to use during this process as well.
winsouce.jpg)