Electronics Forum | Fri Sep 30 12:16:28 EDT 2011 | tomattek
Our company would like to be able to inspect 0201 parts using our YesTech YTV 2050. To do this, we have purchased a doubling lens from YesTech that attaches to our top camera. The problem is, we bought our YesTech used from another CM, not from Yes
Electronics Forum | Mon Jul 13 05:54:39 EDT 2009 | rway
Hello all, We are looking to purchase another AOI system with side angle cameras. Currently we are using a YesTech M1 system that has only a top-down camera (it can't be upgraded with side cameras). Does anyone have experience with YesTech F1 sys
Electronics Forum | Fri Jan 19 08:03:07 EST 2018 | babe7362000
Is anyone Familiar with Yestech B2 Calibration. I can not get the Camera angle to pass. Please message me if you can help me. Thanks
Electronics Forum | Tue Sep 04 16:51:51 EDT 2007 | jseagle
Does anyone use the side cameras on the YesTech or Mirtec AOI systems? If so, how are you using them? Automated side inspection or as a tool to manually evaluate calls? Thanks James
Electronics Forum | Fri Oct 05 09:03:36 EDT 2018 | dontfeedphils
Yea, probably need a new board, which may be tricky considering how old these models are getting now. I had a B2 at my last shop and we upgraded to a Koh Young Zenith 3D. At the time, Yestech told us the camera in the B2 would go for around 10k jus
Electronics Forum | Fri Sep 05 19:56:56 EDT 2008 | hegemon
We did extensive side by side (by side) testing of three AOI machines Omron, YesTech and Mirtec. In the end, even with weighted scores, the difference in the top two machine was still only four/tenths of a point. Third place was a distant 14 points
Electronics Forum | Mon Oct 07 22:06:43 EDT 2013 | action_101
I successfully inspect solder on plcc's with angled cameras on the yestech we have. In the past I have successfully inspected for solder with angled cameras on mirtec machines for both plcc's and qfn's. Other than inspecting solder on those two types
Electronics Forum | Mon Dec 21 12:09:21 EST 2009 | andrew_11
Hello Dany, i had been invloved in a evaluation at another company between omron,yestech,mirtec,vitech.. I found omron and vitech too long to program for hi mix low volumee. yestech and mirtec programmed quickly. I found the mirtec to find more of t
Electronics Forum | Wed Aug 16 21:48:24 EDT 2023 | dwl
Its been a long time and the brain is foggy but if I remember the F1 and B3 use the same software and are very similar other then the B3 is a benchtop and the F1 is in line. Camera resolution and the number of cameras are the things that might be dif
Electronics Forum | Wed Aug 27 11:09:55 EDT 2008 | fede
I�m interested in the F1 model, due to the possibility of this system to be configured with 1 top camera and 4 side. We are manufacturing 0402 and 0.4mm fine pitch Lead Free, and our PCB�s quality is not very good. With just one camera are you able t
