Electronics Forum | Fri Aug 02 12:12:40 EDT 2013 | simplycomplex85
We have a YesTech YTV 2000. I'm being asked to set up a program to test the destination solder on through hole parts to make sure there is a lead in the hole and there is solder in the hole. If possible I need to test for bridging also. This is being
Electronics Forum | Fri Jul 22 18:22:36 EDT 2011 | garym4569
We have a inline YesTech YTV-2000 in a newly configured SMT line and having issues with the transfer system. Shortly after the unit is put in run mode, the conveyor will turn on and run as if it is attempting to load a pcb even though no pcb availab
Electronics Forum | Mon Apr 05 09:33:42 EDT 2010 | flanz
Hello. I'm new to the group and would like to ask a question about a YTV-2000 that I have. Question is - Could someone explain why my Yestech 2000 has a hardtime with calibration? What happens is that I run calibration before I start a new board.
Electronics Forum | Wed Apr 23 15:23:16 EDT 2008 | cassedra
I am looking for users of YesTECH AOI that would be interested in comparing notes on what minor problems you have had and how you may have figured out what you could do that didn't require YesTECH support? Or little tricks that help you make the mac
Electronics Forum | Sat Jul 30 21:47:26 EDT 2011 | garym4569
We just installed a YTV2000 and are having issues with the conveyor SMEMA. YesTech tech support seems eager to help, but we have not found a solution. You may give them a call. If your AOI has internet access and depending on the model, tech suppo
Electronics Forum | Thu Aug 02 10:48:29 EDT 2018 | dleeper
I'm going off fuzzy memories for a YTV-2000 but its probably not too different for the 1000... The motor drivers need to be configured for the specific axis they are driving. This should have been done by Yestech before they shipped them to you. If
Electronics Forum | Wed Aug 16 21:48:24 EDT 2023 | dwl
Its been a long time and the brain is foggy but if I remember the F1 and B3 use the same software and are very similar other then the B3 is a benchtop and the F1 is in line. Camera resolution and the number of cameras are the things that might be dif
Electronics Forum | Thu Aug 02 15:06:03 EDT 2018 | jeffallen662
They where bought directly from YesTech and were guaranteed to be programmed from YesTech.
Electronics Forum | Mon Nov 12 15:28:28 EST 2012 | rway
YesTech recommends to calibrate every 6 months. So yes, annually at the least.
Electronics Forum | Thu Aug 02 14:10:55 EDT 2018 | jdengler
Could they be on the wrong axis from what they are configured for (X and Y swapped)? Jerry
