Electronics Forum | Fri Jul 22 18:22:36 EDT 2011 | garym4569
We have a inline YesTech YTV-2000 in a newly configured SMT line and having issues with the transfer system. Shortly after the unit is put in run mode, the conveyor will turn on and run as if it is attempting to load a pcb even though no pcb availab
Electronics Forum | Thu Aug 02 10:48:29 EDT 2018 | dleeper
I'm going off fuzzy memories for a YTV-2000 but its probably not too different for the 1000... The motor drivers need to be configured for the specific axis they are driving. This should have been done by Yestech before they shipped them to you. If
Electronics Forum | Wed Aug 16 21:48:24 EDT 2023 | dwl
Its been a long time and the brain is foggy but if I remember the F1 and B3 use the same software and are very similar other then the B3 is a benchtop and the F1 is in line. Camera resolution and the number of cameras are the things that might be dif
Electronics Forum | Sat Jul 30 21:47:26 EDT 2011 | garym4569
We just installed a YTV2000 and are having issues with the conveyor SMEMA. YesTech tech support seems eager to help, but we have not found a solution. You may give them a call. If your AOI has internet access and depending on the model, tech suppo
Electronics Forum | Thu Aug 27 10:22:59 EDT 2009 | dwl
We have an opportunity to purchase a Yestech YTV-1000 AOI machine. I am looking for opinions on how well they work and how they compare to the newer Yestech B3 AOI systems. We are a high mix, low volume EMS company. We do not currently have any exp
Electronics Forum | Fri Jun 17 17:11:59 EDT 2005 | stansmt
I have been working with the Yestech system in my facility after evaluating the Mirtec. The yestech system has far less false calls and better defect coverage based on the test vehicles I ran. The YTV-1000 out performed the Mirtec in defect detection
Electronics Forum | Sat Nov 08 16:55:22 EST 2008 | rway
I think you'll find that the YTV-F1 system is comparatively priced at around $100K. Plus it has a color camera and more functionality than what you will get with the Landrex system. You might also look at what Mirtec has. I have only used them for
Electronics Forum | Fri Aug 02 12:12:40 EDT 2013 | simplycomplex85
We have a YesTech YTV 2000. I'm being asked to set up a program to test the destination solder on through hole parts to make sure there is a lead in the hole and there is solder in the hole. If possible I need to test for bridging also. This is being
Electronics Forum | Wed Apr 23 15:23:16 EDT 2008 | cassedra
I am looking for users of YesTECH AOI that would be interested in comparing notes on what minor problems you have had and how you may have figured out what you could do that didn't require YesTECH support? Or little tricks that help you make the mac
Electronics Forum | Thu Jul 28 18:53:32 EDT 2011 | rway
Make sure your system is not in bypass mode (under conveyor setup). Also, the intermittent SMEMA signal can cause the conveyor to turn on until it times out. Check your sensor on the upstream conveyor. Cover it and check your diagnostics to ensure