Electronics Forum | Thu Mar 23 09:29:58 EST 2006 | Joe
I agree that it's the probably the chain. The links get dirty and can bind up over time. When you pull the chain, check to see that each link rotatates freely with its adjacent link. I bet you'll find one or more links that are binding. This is the s
Electronics Forum | Mon Mar 20 09:28:47 EST 2006 | PWH
We just went through this exact same problem on an OmniFlo. We did all the stuff Marc talks about and the problem went away completely. As Marc states, clean the chain guides! You will will see lots of junk near the last zones(s).
Electronics Forum | Mon Mar 20 09:08:42 EST 2006 | mapell
AR Sounds like dirty chains... couple ways to check... Pull off the drive chain for the conveyor. Place a wrench on the (unload end) drive shaft and spin, if it is a bit tough.. dirty rails. Also look at load end of chains. The chain goes low and w
Electronics Forum | Mon Dec 11 20:44:37 EST 2006 | davef
Title : LEAD-FREE WAVE SOLDER FLUX EVALUATION Author : Michael Havener Author Company : Benchmark Electronics, Inc Date : 09/25/2005 Conference : SMTA International Abstract : The European Union�s deadline to ban lead in electronic pr
Electronics Forum | Tue Feb 15 03:56:18 EST 2022 | cbeneat
Is the wheel that drives the belt in alignment? I assume all the bearings are turning. We've had bearings in the past be on the edge of seizing in our end pulley's. Tightening too much could cause it to turn harder, causing the belt to jump off. Coul
Electronics Forum | Tue Nov 15 16:57:22 EST 2005 | bk
If your problem is happening part way through the calibration the problem might be there is too much friction from your Y-wagon. Measure the friction on the Y-wagon using the service program if it fails or if it is near the max allowed try oiling up
Electronics Forum | Thu Oct 30 09:23:34 EDT 2008 | jwolvans
Hi, Rob. Does the table appear to hang up, then suddenly let go? If so, check the alignment of all four conveyor rail guide blocks, especially if the clamping rails have been recently removed for maintenance. After that, check the piston assembly t
Electronics Forum | Tue Sep 19 22:45:19 EDT 2006 | darby
Larry, The Quad is based on the Samsung - yes? If so, here are the final recommended answers from Samsung. All LM guides and bearings, ball splines and rack and pinion use Shell Alvania EP2. Sometimes called LF2. Sometimes called Albania. It's a dar
Electronics Forum | Thu Jan 29 12:47:53 EST 1998 | Henry Lee
I have an Electrovert Ultrapak 445 Wavesolder machine with 3 IR preheat zones and a single wave with omega wave. I want to run a DOE (Taguchi) to determine the optimum settings for soldering both single-sided and double-sided boards. Can anyone po
Electronics Forum | Wed Sep 27 15:57:33 EDT 2006 | SWAG
I wanted to post resolution on a reflow oven problem we had but can't seem to search out the old thread. So, this is new but old. Our OmniFlo 7 conveyor was stopping every once and a while and the speed indicator on screen said 1000+ ipm. We cle
winsouce.jpg)
