Electronics Forum | Tue Feb 21 10:45:45 EST 2012 | acsscott
Thanks for the password. There is a 7 pin connector for the Emergency stop in and out. It has a mate with a jumper wire attached to the Topaz end. If you put the jumpered mating connector on this, the emergency stop errors go away. The other conn
Electronics Forum | Tue Mar 20 16:23:20 EDT 2012 | hegemon
Based on my experience with OMRON VT-RNS, I would not consider this machine unless you are running high volumes of a limited number of assemblies. Programming and debug took a lot more time than than other machines in the same price range. After deb
Electronics Forum | Wed Apr 04 13:40:22 EDT 2012 | rway
I agree, the only way to "truly" inspect a QFN is with an X-ray. But this might be over-kill for him. He asked about soldering, not inspection. We use QFN's regularly and you can inspect these parts from the side to see if they are soldered. Unfo
Electronics Forum | Mon Apr 02 09:57:18 EDT 2012 | vparis
Our company is having issues with our YesTech F1 AOI machine the programs are currently not utilizing this machine correctly. we are have a false call rates of about 5% to as high as 12% of the total number of inspection points. I have started to rep
Electronics Forum | Mon Jun 11 17:47:54 EDT 2012 | tombstonesmt
Pete B *We do lines of soldering @ 10mm/sec *Similar solder balls were present on product after soldering. *UPDATE SOLUTION* We began using topside preheat while fluxing the board to reduce the thermal shock factor in addition to replacing the "fi
Electronics Forum | Mon Apr 16 13:31:36 EDT 2012 | jdengler
Have you tried to restart F4G and/or MCS/30 after flushing the CP4 memory? I have occasionally ran into the comm error after a reset start. Leave the machine on and restart F4G or the MCS/30 whichever normally is hooked up. If it still won't commu
Electronics Forum | Wed Apr 25 19:44:45 EDT 2012 | padawanlinuxero
I think we all have come to ask the same question, sometime in our career, like you and everybody else we try to comply with the 5S's in our desk, but is just no way we can maintain the level of cleanness and order the 5S requires, yes we can have a
Electronics Forum | Tue Apr 24 02:34:31 EDT 2012 | abyan
Hi..i have o project to make 3A Power supply, and i want to make it using SMD. I want to ask you about SMD capasitor, because i'm a newbie in this type of material.. Actually where could i found SMD capasitor with this specifications: -) 6800uf 35vol
Electronics Forum | Thu Apr 26 16:36:35 EDT 2012 | davef
Stencil Cleaning [AIM LeadFree] * Stencils should be cleaned frequently enough to ensure total removal of any bottom side residues, but not so infrequently as to allow the same residues to dry or cake on, making their removal much more difficult. * S
Electronics Forum | Fri May 04 12:19:53 EDT 2012 | gnus
I'm guessing you're running small batches of boards on the MyDatas. We had the same issue with management when they decided to save on parts (not realizing it cost them more in time and more frustration for us). We had Agilis feeders so that helped.
.png)
