Electronics Forum | Tue Jun 18 09:51:53 EDT 2013 | rway
If they're 1 1/2 years old, they are definitely aged parts. Either send them back for newer or widen your tolerances on the ICT to compensate. You are at the 3rd decade now (10,000 hours) and you will need to compensate for this. These parts are n
Electronics Forum | Sat Jul 06 19:49:41 EDT 2013 | sarason
My software can easily open a PCB CSV file so this is probably the easiest way for you to generate a file. The setups are remembered via a write to the registry, so you can go with a standard set of values to arrive at a very usable file without havi
Electronics Forum | Thu Aug 01 16:28:17 EDT 2013 | jimmyboz
Does anyone have info on the "Cycle Steel" > function on the Fuji XP141 machines. I am new to > the industry and have not had any luck finding > information on it. I talked to Fuji and they > just tell me to leave it on, it will help with > pl
Electronics Forum | Wed Sep 11 20:36:04 EDT 2013 | action_101
UIC still manufacturers new thru-hole machines. Both axial and radial insertion models are available. They stopped making the multi-mod dip inserters in '91 or '92. And parts are easily acquired for any older models, there were a ton of machines out
Electronics Forum | Fri Jan 31 11:45:52 EST 2014 | emeto
Hi, to get better image you will probably need higher voltage(depending on how close you want to look). The closer you get the higher the voltage should be. Here are some tips for machine calibration: 1. Make sure your board is on focus. I don't kn
Electronics Forum | Thu Apr 03 17:39:37 EDT 2014 | siddharth
You are correct. Both the machines are "semi-automatic". The program can focus on the part you want to inspect and perform basic inspections like void analysis (BGA, QFP) etc. But you have to manually navigate and look for defects like TH solder fill
Electronics Forum | Thu Jul 03 13:15:35 EDT 2014 | rgduval
If you are developing a cost model for quotation/estimation purposes, we would recommend time studying a handful of existing jobs/set up's that you have, and averaging your actual CPM rate. Then determining your cost to operate from there. This wil
Electronics Forum | Tue Aug 05 21:08:10 EDT 2014 | isd_jwendell
You are correct about the Manncorp machine, it was an MDC machine. The Essemtec machine is old(ish) but still runs fine, and last I knew they were still supporting it. My recent problem with Essemtec was in regards to software. I found a bug and sim
Electronics Forum | Fri Sep 05 09:22:53 EDT 2014 | rgduval
Hi, Rebecca, Hmm...two x motors? I'm a couple of years removed from MyData's, but, I don't remember two x-motors. Might be something in the My12's that I didn't see in my older My9 (and certainly not in my TP9). As to the small board...unfortun
Electronics Forum | Fri Sep 05 09:33:32 EDT 2014 | cflames17
It could very well be the Safety Relay located inside the ELMO PSU (Bottom left in computer cabinet). I just had the same problems on 2 MY9's within 2 months apart. the Part cost around $700.00 from Mydata (Now Mycronic). These fail commonly with old
.png)