Electronics Forum | Fri Sep 05 09:22:53 EDT 2014 | rgduval
Hi, Rebecca, Hmm...two x motors? I'm a couple of years removed from MyData's, but, I don't remember two x-motors. Might be something in the My12's that I didn't see in my older My9 (and certainly not in my TP9). As to the small board...unfortun
Electronics Forum | Fri Sep 05 09:33:32 EDT 2014 | cflames17
It could very well be the Safety Relay located inside the ELMO PSU (Bottom left in computer cabinet). I just had the same problems on 2 MY9's within 2 months apart. the Part cost around $700.00 from Mydata (Now Mycronic). These fail commonly with old
Electronics Forum | Tue Dec 23 12:34:27 EST 2014 | deanm
I'm sure you considered acquiring a second FX-D and run them inline, the first dispensing half the board and the second the other half. That would automatically double your throughput. You wouldn't have to worry about a new process, consumables, et
Electronics Forum | Mon Feb 09 09:00:17 EST 2015 | jax
Outside the MSD issues stated already (and I cannot provide a exact time not knowing multiple factors like Humidity levels, temps, exposure times, etc...) OSP might be the very worst finish to use in this scenario of side 1 / store on a shelf / side
Electronics Forum | Tue Apr 14 20:28:03 EDT 2015 | carlosdugay123
Hello Marshall, I represent Metal Etch Services, we manufacture SMT Single and Multi-Level Stencils, we have over 25 years experience and one of the reasons most of our customers like us is because we offer technical assistance. Regarding the issue y
Electronics Forum | Mon Mar 30 09:52:56 EDT 2015 | rgduval
Seems like you've got it about right....though, it's a rather complex equation. Loaded labor cost is only a part of it, if you're trying to estimate down to the last cent. You have to account for energy utilization, space utilization in the factory
Electronics Forum | Sun May 31 11:19:19 EDT 2015 | visionbot
Good luck Alexandru. I went through this years > ago and it is a lot of fun. For the next 5-6 > years you will learn a lot about P&P systems, as > you will get your feedback from your > customers(trust me it is going to be a lot and > you will
Electronics Forum | Thu Sep 24 09:28:13 EDT 2015 | rgduval
No direct experience with this particular issue....but, I do know that measuring capacitance can be tricky. How are you arriving at this conclusion? Are you measuring the caps on the bench before assembly, and then on the boards post assembly? Cap
Electronics Forum | Sat Sep 26 02:09:39 EDT 2015 | aemery
Proc My field service back ground included Electrovert so I know reflow electrical quite well. I've worked on Heller, Conceptronic and Vitronics over the last few years and really there isn't a huge difference if you can read a schematic. I checked
Electronics Forum | Tue Nov 10 15:25:37 EST 2015 | 31258
Good morning RedChili, This is Marvin from Saki America. I came across your post and I noticed that you are interested on 3D-AOI and 2D-AOI machines. We can offer pre-reflow and post-reflow full 3D-AOI and 2D-AOI for you needs. IF you have any ques
