Electronics Forum | Thu Dec 15 01:21:42 EST 2005 | bvdb
We own a Fuji IP1 with all the manuals, etc. but can't figure out how to inch the tray robot. We can inch the X, Y, Z, Q axis and the SX and SY axis. All the axis auto zero OK (including the trays), but when I push the "4" key to inch the trays we
Electronics Forum | Fri Oct 28 02:18:03 EDT 2022 | kamedatec
I bought a YV100XG machine with AutoTC (Automatic Tray Feeder), Everything is working except AutoTC, when I active this function, pops up the error that the Servo Motor LZ1 was not found. I changed the control card of the servo motor, checked the wir
Electronics Forum | Mon Apr 01 17:02:58 EDT 2013 | microaide
Yes! Thank you. That was not intuitively obvious, nor did the manual make that point clear at all. I can now create new SMD Types. Now if I just had the foggiest idea on how to set up and assign feeders, I might be able to generate my program. Right
Electronics Forum | Wed Apr 03 16:07:13 EDT 2013 | microaide
OK, so I think I have figured out the machine configuration for tape feeders. BTW, your procedure for retrieving the X/Y/Z coordinates for the pickup locations was wrong. So I looked it up in the Quad manual. The manual was wrong too. Correct procedu
Electronics Forum | Tue Oct 26 00:03:09 EDT 2010 | jmelson
Hmm, that's a fairly old machine, even older than mine! (I have a CSM84 PA130640). Anyway, it is best to program the machine from CAD system data, I wrote a little program in C to read in the component type and XYR position, and produce the file in
| 1 |
winsouce.jpg)
