Electronics Forum | Thu Dec 05 08:49:43 EST 2002 | pjc
Yamaha YV100Xg is the Topaz XII YV100X is Topaz X YV100II is Topaz YV88Xg is Emerald XII YV88X is Emerald X YVL88II is Emerald YV180Xg is Sapphire XII
Electronics Forum | Tue May 18 08:57:28 EDT 2021 | compit
PS. I bought in China, i'm sure there you will find the right :)
Electronics Forum | Fri Aug 27 07:46:47 EDT 2021 | compit
No. "The target position is outside the moving area".
Electronics Forum | Thu Aug 26 20:35:33 EDT 2021 | kumarb
Hi. Have the Emerald-X (Yamaha YV88X) unit. Works fine. Using F9 (Teach & Trace), we can position to most locations on the front feeders (not to the extreme left or extreme right due to the head design). Should the unit be able to do the same for t
Electronics Forum | Tue Apr 19 21:23:37 EDT 2022 | kumarb
Hi. On our YV88X (Emerald-X), we use the edge clamp + Push-IN clamp to secure the PCB. The push-in metal part pops up fine but unable to move this piece to the LEFT or RIGHT using the dial inside the machine. The latch inside the machine is rotated '
Electronics Forum | Tue Jun 22 06:53:31 EDT 2021 | vinitverma
Change Feeder position from 'Automatic' to 'Relative'. And enter the feeder location of whatever rear feeder you want it to be at. Optimisation won't move it then.
Electronics Forum | Thu Jun 24 10:03:18 EDT 2021 | joost
i did not know that! i learned something today, thank you.
Electronics Forum | Tue May 18 08:55:06 EDT 2021 | compit
I bought similar (KOGANEI) for Topaz-X, only the coil of the electromagnet must be the same (voltage). The mechanical part is unlikely to break down - you need to disassember and clean.
Electronics Forum | Wed May 19 20:31:12 EDT 2021 | compit
joy@joysmt.com or from Elissa (I can check the address tomorrow - a person known on this forum).
Electronics Forum | Sat Aug 28 13:20:08 EDT 2021 | kumarb
Thanks Michal. Will need to do more homework for our next machine. Considering the YSM10 or YSM20 but only once we fully understand the features and shortcomings of each.
