Electronics Forum | Mon Dec 22 04:55:41 EST 2014 | bobpan
Swap the amps but first manually check by hand to make sure the z-axis is free to move up and down. Sometimes a part can get stuck in the gears. Good Luck
Electronics Forum | Fri Oct 04 14:15:21 EDT 2019 | ddfreeze
that doesn't seem to be the issue here
Electronics Forum | Mon Oct 21 19:42:08 EDT 2024 | tomazicrok3
Hi, I have Samsung CP40CV pick and place machine. And i want to know if i can somehow disable head 3 because i get cant restart motor alarm and some z axis error. Greetings
Electronics Forum | Fri Oct 04 13:47:25 EDT 2019 | compit
I had as I placed the supports at the back - when lifting Z touched the rear rail - check.
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Wed Dec 04 08:02:02 EST 2019 | proceng1
Contact George Castonguay at PPM. He is a Jedi when it comes to these machines. In fact, since you just got it, a good investment would be to have George come in and go through the machine and get it calibrated. 603-895-5112 They also sell parts
Electronics Forum | Mon Oct 07 16:07:22 EDT 2019 | ddfreeze
I have a silver aluminum z axis sensor that is not mounted, I need to know where it goes. The sensor has a picany rail type mount, triangular rail insert type. It is located in the board support nest area. Seems like it might go on the inside of the
Electronics Forum | Fri Dec 19 17:11:24 EST 2014 | guts1872
My QSP2 motors keep shutting off with an error message on the screen that says Z1 motion fail. Z safe motion motion failed due to previous error. When homing the heads I observe the servo amp indicator LEDs. They are all green while the gantries are
Electronics Forum | Thu Jan 18 10:05:44 EST 2007 | SWAG
Make sure the program has been optimized to the current nozzle configuration.
Electronics Forum | Fri Jan 12 08:41:12 EST 2007 | geb
Hi, Our GSM1 pick and place machine has an Axis head 2 Z velocity error. None of the spindles of Head 2 work during placement and it brings up the error message. It will not proceed after that. I have tried lowering and raising the spindles in the
.gif)