Electronics Forum | Mon Dec 19 16:47:19 EST 2005 | Steve
Bert: Try this: Set Servo Press Axis Key # 4 to prompt machine ID Hold in Axis key # 1 and input ID (typically 0 - check machine proper) Release ID key, continue to Hold #1 key Press Release #1 key Then Release You will now be able to Jog the Tray
Electronics Forum | Wed Jun 24 16:10:09 EDT 2020 | landrysmt
Hello, Finaly, What was the problem on your Hydra head? Maybe my message comes too late, but my answer might help ... It could be linked to a problem with the Hydra Z motor / encoder. In certain circumstances, the Hydra Z axis is not in the correct
Electronics Forum | Thu Jun 06 03:49:50 EDT 2002 | ianchan
Sam : Hi, goto "www.yahoo.com", under yahoo search option and literal type the following sentence: "AXI" and "AOI" and "Agilent" click "go" button, search engine will generate lotsa crap, some of it will be what you want. Agilent is marketing it
Electronics Forum | Mon Jul 26 21:56:53 EDT 2004 | pdeuel
The camera is not driven from the motor cards. The camera is attached to what is called a forcer. For the Y axis there are two of them. One is wired backwards from the other. one of the forcers is connected to a flex chanell for the air and electrica
Electronics Forum | Mon Oct 20 10:08:42 EDT 2014 | rgduval
Had someone in from the broker that we bought this machine from, and he did some poking around. We've learned some things, but, unfortunately, are still no closer to getting the machine running :( We discovered (based on double checking other machi
Electronics Forum | Sun Apr 12 08:49:12 EDT 2009 | mki
Hello, I bought used QUAD IVc MKII with transport in "as-is" condition, powered it up (without air and PCB on machine) and all axes (X, Y, Z AND T(heta)shows signs of life. Machine is performing HOME positioning self test. I am not familiar with QUA
Electronics Forum | Tue Apr 05 12:01:17 EDT 2005 | blueflag
Thanks for reply we have found a blown fuse on the back plane for the mot-z pcb . But we now have problems with Z height, i am trying to auto-teach devices from the tray wagon (qfp etc) and it is not always lowering the nozzle to the component. i ha
Electronics Forum | Wed Jun 30 20:32:44 EDT 2021 | rgduval
Check the friction numbers...there could be an issue with the z-wagon bearings, or something else adding tension to the z-travel. Also make sure there are no cables interfering with the z-travel. Could be a cable that moves into the way at some spe
Electronics Forum | Wed Jun 03 21:49:27 EDT 2020 | bboyer
Well, we finally got the machine to power up and fully boot, but now we are having issues with zeroing the axes. X, Y and Theta zero OK, and the board conveyor runs, but when it tries to zero the PWC, the rail moves to the rear of the machine, hits
Electronics Forum | Fri Dec 19 17:11:24 EST 2014 | guts1872
My QSP2 motors keep shutting off with an error message on the screen that says Z1 motion fail. Z safe motion motion failed due to previous error. When homing the heads I observe the servo amp indicator LEDs. They are all green while the gantries are
winsouce.jpg)
.png)
