Electronics Forum | Tue Aug 07 12:18:37 EDT 2001 | delnosa
Looking at ideas for "best in class" process controls for SMT mfg. ops. Wanting to add improved p-controls at some of our suppliers and I'm looking at what others may or may not recommend. Already looking at the following: Solder Printing X-Y-Z axis
Electronics Forum | Sat May 30 07:06:42 EDT 2015 | et1972
Hi I have a MPM3000HI printing machine with a following problem : Unable to run at high speed for z axis ,machine will stop at certain points . Have change ballscrew,nut ballscrew,motor and brake but still the same. Now run at low speed at 1 but t
Electronics Forum | Thu Feb 12 13:01:12 EST 2004 | patthemack
Thanks for your response. This is a DeHaart MPC-29. It has manual vision, no conveyor. When I bought it, only one camera was working. I fixed that, but while I was jacking with that, the electronic pressure regulator (spcjr) burned up without warning
Electronics Forum | Thu Mar 21 12:09:28 EDT 2019 | alexcouto
Hello Bukas, thanks again. Since at an early stage I switched heads # 1 and # 6 and they are not compatible, then I went through the manual and figured out why. in order to start at the beginning and check that it had not damaged anything, I put the
Electronics Forum | Mon Jun 12 17:54:17 EDT 2017 | simons
The machine does not move to the home position. Once we hit the "Home" button all three heads will move up to the "Home" position but then 5 to 10 seconds later the following error pops up "Error 1531 - Z Axis motor alarm" before any "xy" movement i
Electronics Forum | Mon Sep 14 16:36:40 EDT 2015 | simons
Upon start up our QSA machine is giving us the following errors. Cant reset motor alarm (x axis) Cant reset motor alarm (y axis) Cant reset motor alarm (z axis) What are the possible reasons for this? Thanks
Electronics Forum | Tue Jun 23 08:08:38 EDT 2009 | ptxems
We have a couple of Zeva/Juki PM570L's. One machine has developed a fault with the z axis motor. It is continually 'buzzing', we have checked and there is 24VAC on it. Although even on the other machine there is AC voltage on the motor. We have sw
Electronics Forum | Tue Feb 21 08:12:11 EST 2012 | vparis
Hey I am in need of the following replaclment parts for an MPM SPM-AV s/n: 7095 Im looking for the Z-Axis Motor MPM p/n: 000298 and a Z axis belt MPM p/n: p2387 Let me know if you have any of these or you can shoot me in the right direction.
Electronics Forum | Sat Nov 14 08:00:34 EST 1998 | Earl Moon
| Also the preheating of the board is done to help evaporate any water/alcohol that is in the flux - water is a big problem in No-clean processes. From our experience, a temp range around 200f - no more than 220f is ideal for the bigger boards, but t
Electronics Forum | Tue Nov 01 09:36:41 EDT 2011 | emeto
THe question is - does that happen on all of your programs or just in one program? If it is just this particular board, it might be some softwaRE limit issue. If it happens on more programs it is a hardware issue and it could be one of the following: