Electronics Forum | Sat Jun 25 01:05:13 EDT 2005 | pci
check the X axis belt , guides and Z axis motor
Electronics Forum | Fri Apr 02 14:21:58 EDT 2021 | sacd
deleted
Electronics Forum | Tue Oct 01 18:44:24 EDT 2013 | richardconnell
Hi, I have limited capability on the Z axis. The axis will home to the mechanical switch limit and then drop to a point which I asssume to be the fiorst zero point below the mechanical switch limit. Then it gives the error. There is power to the mo
Electronics Forum | Thu Mar 17 12:45:54 EST 2005 | Micheal
I am looking for the Procedure to Calibrate the Z-axis gears (blades) on a MPM SPM Screen Printer. Does anyone have it, I would appreciate it.
Electronics Forum | Mon Feb 27 21:08:21 EST 2006 | ChrisG
I have never seen that message before, but you should check the Z axis driver card, and the Z home sensor. Do you hear anything when the axis tries to move?
Electronics Forum | Tue Sep 23 13:46:56 EDT 2008 | jeffjarmato
Does any one have a manual on this press? I am having problems with mine during homing. It seems that the Z axis sensors are not seeing the Z axis and it runs into hard limits. Thanks for any help provided
Electronics Forum | Thu Jan 29 10:05:28 EST 2009 | soudomphong
I am looking for rolling table z-axis p/n 00320165-02. for rv-d head siemens S20. Anyone know where to get it or have it, please contact me via email seth.oudomphong@variosystems.com Thank you. Seth
Electronics Forum | Tue Oct 14 07:38:29 EDT 2014 | dilogic
Z axis drivers are located in co-salled LP servo bay. It is 19" rack mounted in lower left part of the machine. Head1 z axis driver is in slot 4 and head2 driver is in slot 6
Electronics Forum | Wed Oct 24 07:33:44 EDT 2018 | tech1
when the machine initiates the last move it does is in the Z axis. If memory serves me, during the last Z move it drives down and measures the stroke, if the lower solenoid is not fully retracted the axis measures the wrong travel limits. Hopefully t
Electronics Forum | Mon Aug 14 11:30:25 EDT 2006 | SWAG
We had centernest to I/O track alignment problems that were not predictable on 3000. Z-axis height seemed good with relation to I/O tracks but y was misaligned. Ended up replacing y-axis stepper and trouble went away. Also have had trouble with z-
