Electronics Forum | Wed Feb 11 08:33:25 EST 2015 | daniel_esposito
Hi, I have two Quad IVc and both of them have the same problem. Laser Alignment is not working! When I run funtion 30, it always gives 1 at nozzle height. If I place any object beside the nozzle, it will give a number different from one depend on how
Electronics Forum | Thu Mar 18 12:32:16 EST 2004 | steve_arneson
There are many low cost paste inspection systems on the market today. It really depends upon your overall needs for process improvement. The CyberOptics LSM series of inspection devices use a single laser stripe to calculate both Height, Area and V
Electronics Forum | Thu Dec 20 07:08:07 EST 2018 | robl
Hi Prem, OK... Is it definitely ok before the oven, as it's a big part to move. Never had an issue with them. Has the part got the correct z height on or is the paste being displaced on placement What machine are you placing it with (is it laser
Electronics Forum | Tue Mar 12 09:23:52 EDT 2013 | bobpan
If you edit the sequence on the hht.....to fix your problems...you then have to upload the data to central controller. If you are not doing this....you are overwriting the data on the machine with bad data everytime you download to the machine. The l
Electronics Forum | Tue Mar 12 09:24:47 EDT 2013 | bobpan
If you edit the sequence on the hht.....to fix your problems...you then have to upload the data to central controller. If you are not doing this....you are overwriting the data on the machine with bad data everytime you download to the machine. The l
Electronics Forum | Tue Oct 10 11:06:04 EDT 2006 | lheiss
Hi All, I wasn't sure how this would turn out until I ran some production. As I suspected, after every nozzle change the machine dumps the first 3 pickups, checks the nozzle height again (function 30?) and then begins placing with correction with n
Electronics Forum | Tue Jan 12 17:56:18 EST 1999 | Jason Hall
| For process management with SPC of the stencil printing process with a fully automatic stencil printer, what process outpur parameter would you recommend for SPC? | | It appears to me that there are two options: | A: to have a pn chart based upon
Electronics Forum | Wed Sep 04 13:58:36 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the response. 1. Function 30 gives me a consistent 182-185, even after nozzle changes. I can vary this by changing mod code 15 and I have been advised to aim for 90-110, but it doesn't seem to make any difference so I've go
Electronics Forum | Fri Apr 06 08:45:30 EDT 2018 | rob
Hi Reckless, No, I don't think it's a $1K job, just for the hours needed. You still need to learn the absolute basics, such as navigating the menus, creating a program, nozzle changing, identifying parts with the laser and camera, Pick timers, z hei
Electronics Forum | Fri Mar 13 15:09:20 EDT 2015 | marcelorotofrance
Hello everybody Lately our machine has been working pretty well, but it can’t last too long. Now, during this week’s production cycle, it began to increase the component’s reject rate to alarming levels (obviously the operators reported me when the m
