161 z motor results

Electronics Forum: z motor (Page 1 of 17)

Samsung cp40cv motor and z axis error

Electronics Forum | Mon Oct 21 19:42:08 EDT 2024 | tomazicrok3

Hi, I have Samsung CP40CV pick and place machine. And i want to know if i can somehow disable head 3 because i get cant restart motor alarm and some z axis error. Greetings

MyData My9 &quot;no z indicator value at all&quot;

Electronics Forum | Mon May 09 19:24:53 EDT 2022 | rgduval

It's been a minute...but, does the My9 still have MOT boards in the computer cage? If so, swap the MOTz with the MOTx or MOTy, and see if the problem moves. If so, replace the motor controller board. If not, +1 on the encoder or Z-motor. Check fo

Z motor temperatusensor disconnected

Electronics Forum | Sat Feb 22 09:47:44 EST 2020 | tomdegas

When I run the "Service" software and I look at the status of the HYDB in the Utilities tab, it comes back with all is good except that the Hydra motor temperature sensor is "disconnected". Can anyone tell me where this sensor is and is it replaceabl

MyData My9 &quot;no z indicator value at all&quot;

Electronics Forum | Mon May 09 19:27:19 EDT 2022 | mikevb

Thanks for the response. Yes, the z motor initializes in the service program just fine. It moves and reads a position. Also in the service program, I try to test the z force sensor and it gives me the same error - no z indicator at all. All cables ar

MyData My9 "no z indicator value at all"

Electronics Forum | Mon May 09 19:00:47 EDT 2022 | SMTA-64387687

Z-force sensor is a tool travel indicator. It has nothing to do with Z travel. Does the Midas head move at all, during initiation? It sounds to me like a Z motor/encoder problem. Is the Midas head ribbon cable plugged in?

QUAD 4C motor error #5

Electronics Forum | Fri Aug 30 11:31:29 EDT 2013 | nophsem

We have two QUAD 4C working in tandem. 3 months ago the EPCU battery (QUAD # 2) died, then we change it. Then downloaded the MODs from the controller to the assembler(does simultaneously on both machines). All this time we continue to work normally.

QUAD 4C motor error #5

Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan

I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse