Electronics Forum | Thu Mar 05 07:40:55 EST 2020 | tomdegas
I swapped the mi boards with ones from a working My12 machine and the same results. To recap my problem: On "Hardware Initialization" the center jaws open and close, the Hydra Theta belt moves back and forth, the Hydra head moves all the way down an
Electronics Forum | Sat Feb 22 09:41:44 EST 2020 | tomdegas
I am getting a F-MOT-MSEDYN HYDRA Z/156 error when I try to initialize Hardware on my My9. Interestingly though when I go into the "Service" program, I can initialize the Hydra Z with no problem. But when I try in TPSys, it doesn't pass and I get t
Electronics Forum | Fri Feb 21 10:50:00 EST 2020 | tomdegas
I am getting the following error on our MY9 during hardware initialization: F-MOT-MSEDYN HYDRA Z/156 Motor Timeout After the Theta test, The HYDRA head moves slowly all the way to the bottom and then moves slowly back up and the system fails initia
Electronics Forum | Wed Mar 04 12:51:41 EST 2020 | bk
That error means your hydra z did not reach it's specified position. With the machine on you should be able to manually push the hydra down and let it come back up. Make sure it isn't being held up or hitting anything as goes down. Lots of times a pa
Electronics Forum | Wed Mar 04 13:45:01 EST 2020 | tomdegas
I appreciate the help. The Hydra travel is fine and goes down and back up with no trouble. I swapped the Z Mot board with the Y Mot board with no change. The long ribbon cables were changed about a month ago but I will inspect them again to be sure.
Electronics Forum | Wed Oct 06 03:58:25 EDT 1999 | Brian
| | Hi, | | | | Help! Could anyone help to enlighten me on this? | | | | Question: | | | | If I have a CSP/BGA package of size X by Y and the standoff gap between the component and PCB is Z, What is the maximum allowable Y/Z or X/Z that using a n
Electronics Forum | Sat Oct 02 03:27:52 EDT 1999 | Brian
| I am currently in the middle of a company wide war and I'm looking for data (AMMO). Here are the problems: | | 1) I am looking for anyone who has done or seen any reports on Thermal Shock to smt parts and/or via holes caused by Soldering Irons at
Electronics Forum | Sat Oct 02 20:19:19 EDT 1999 | John Dwinell
| | I am currently in the middle of a company wide war and I'm looking for data (AMMO). Here are the problems: | | | | 1) I am looking for anyone who has done or seen any reports on Thermal Shock to smt parts and/or via holes caused by Soldering Ir
Electronics Forum | Thu Jul 18 05:05:34 EDT 2013 | bobpan
Make sure that the lens is clean and you dont have any parts down inside on the camera. Also sometimes the leds that shine up to the part are bent in crazy directions. Make sure they look like they are all aimed up at the same direction. Is the brigh
Electronics Forum | Mon Sep 30 16:36:00 EDT 2013 | richardconnell
I have a Universal Instruments Corporation TAB Bonder. Oldish machine. Initial fault on machine : - "Axis Head 1 Z DAC Limit error during move absolute command" Other fault seen after we reset power, Zeroed axis etc. - Axis Head 1 - Z error not re
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
winsouce.jpg)