Electronics Forum | Tue Feb 25 01:32:12 EST 2020 | kcgoh5666
LOOKING FOR THIS CAMALOT GEMINI II Z AXIS BOARD
Electronics Forum | Wed Jan 31 13:00:43 EST 2007 | bvdb
The continuing saga - we got the IP-1 communicating with the MCS16 again by replacing a couple of chips on the VME1152 CPU board and now it's working again but have a new problem. The machine stops about every other time when changing nozzles with a
Electronics Forum | Fri Aug 11 11:18:20 EDT 2006 | chrisgriffin
I got a 3000 that is acting crazy. After a print, the board is unclamped and the Z-axis lowers. It continues to lower until it trips the limit switch. It is suppposed to move in the Y-axis to line up with the tracks while lowering in the Z-axis.
Electronics Forum | Mon Feb 04 08:04:39 EST 2013 | marcelorotofrance
Function 30 reads CENTER 1024 RUN OUT 0.0 with any nozzle and without nozzle at all. However I see that nozzle tip stops in front of laser beam. When I interrupt the beam with a piece of paper during Function 30, Z axis travels down until I take it
Electronics Forum | Tue Oct 20 10:31:50 EDT 2009 | lloyd
Seth, From the Siemens technical information document: Raceway monitoring detects incorrect positioning of the Z axis with respect to the raceway during motion of the star. This is done by monitoring the current drawn by the Z axis while the star i
Electronics Forum | Fri Feb 19 11:17:29 EST 2010 | kpm135
When I try to load a board in our MPM UP2000 HiE I get the following error "Z axis software limit". The Z axis will move up and down freely, I re-calibrated it and reprogrammed the board and the error continues. Has anyone else run into this issue an
Electronics Forum | Mon Sep 05 11:51:30 EDT 2022 | jojoled
Can anybody help with Re-calibrating the Z-axis height in MS parameter , on JUKI KE760L? In MS parameter manual, there is information that these accessories are needed to recalibrate the Z-axis , can anybody tell where to get them, or ideally how to
Electronics Forum | Thu Mar 17 12:45:54 EST 2005 | Micheal
I am looking for the Procedure to Calibrate the Z-axis gears (blades) on a MPM SPM Screen Printer. Does anyone have it, I would appreciate it.
Electronics Forum | Wed Jun 21 09:23:28 EDT 2006 | rmitchell
problem solved. Some PCB table support pins were jammed down in the table preventing the Z axis from lowering all the way. The intial error mesage was x and y servo, but the real error was the z axis overflow. Rob
Electronics Forum | Tue Sep 23 13:46:56 EDT 2008 | jeffjarmato
Does any one have a manual on this press? I am having problems with mine during homing. It seems that the Z axis sensors are not seeing the Z axis and it runs into hard limits. Thanks for any help provided
winsouce.jpg)
.gif)
