Electronics Forum | Tue May 07 15:30:41 EDT 2013 | bobpan
your card is probably bad.....you can ohm out the motor and cable if you want... z motor windings 1.36 ohms z motor cable and windings 1.82 ohms good luck
Electronics Forum | Mon May 09 19:24:53 EDT 2022 | rgduval
It's been a minute...but, does the My9 still have MOT boards in the computer cage? If so, swap the MOTz with the MOTx or MOTy, and see if the problem moves. If so, replace the motor controller board. If not, +1 on the encoder or Z-motor. Check fo
Electronics Forum | Thu Feb 06 20:23:35 EST 2020 | bilalfarooqi
Hey everyone, We use a MyData MY12 machine and we are experiencing a problem with the Midas head. I recently replaced a torn vacuum tube that goes on the zfib card. The machine worked perfectly for a day and a half but now MY12 has completely stoppe
Electronics Forum | Fri Apr 05 11:50:20 EDT 2024 | proceng1
I can tell you that Z motors and Geckos were the items we replaced most often. We had two MACH machines converted to SWAK and didn't have the GECKO issue anymore. But still replaced Z motors and Pump (SP) motors. When I ordered the motors direct,
Electronics Forum | Wed Jun 27 12:27:46 EDT 2007 | jaimebc
Same error here with our GSM1. Does your GSM have 2 heads? If so, this is how I fixed it. I didn't have a spare Z motor, so I swapped the Z motor for the front head with the rear head. Problem gone. Now since we don't use the rear head as much as we
Electronics Forum | Tue Jul 22 09:12:58 EDT 2008 | chiptargets
Hi, I posted a similar message yesterday, but I believe it did not make it through properly. I apologize. We have an error while trying to perform Initiate Hardware test. The error was "F-MOT1-25/205:MOVZ: Motorspeed Out of Control". The error, ho
Electronics Forum | Fri Mar 05 15:43:10 EST 2004 | Quetza
You can have many problems, but the most commons are that your Z belt is too Lose or is time to replace it, the second is that your Z motor went bad. Hope these woks for you
Electronics Forum | Thu Apr 07 08:57:06 EDT 2005 | blueflag
have been through somethings with an engineer on the help desk and the concusion is that it is the z motor with the encoder that is causing the fuse to go so have ordered another. Not cheap though at nearly �500. Thanks very much for your help, it
Electronics Forum | Wed Apr 08 13:21:40 EDT 2009 | cyber_wolf
No it is not normal. The reason it is happening is because the Z motor is in an over current situation. You need to fix the wires and get the connections out of the way.
Electronics Forum | Tue Oct 25 15:03:48 EDT 2011 | sjs2303
Hi Bert, For your second issue, are the tools well lubricated? If not the Midas head can fail to grab the tool and can generate the z motor error. Doing this followed by a base-centre level measurement should resolve your problem. Steve
