Electronics Forum | Sun Feb 12 03:06:04 EST 2012 | dan_ems
Please help me with this: I need a zero Ohm SMD resistor (strap) to connect 2 PCBs but to be like a wire, that can be bent. I need to be SMD because I want to be place it with "pick and place machine". Thank you.
Electronics Forum | Mon Jun 18 12:56:26 EDT 2012 | tsvetan
seems Chinese AOI, I've seen plenty of such in price range $10-12K when I was in China, they have perfect mechanic and poor written software,which make them almost unusable when buy one such machine from China expect near zero support
Electronics Forum | Tue Aug 21 10:52:40 EDT 2012 | swag
We have 2 lightning head machines. We have a very clean, dry air supply. We have had zero spindle problems in 3 yrs.
Electronics Forum | Thu Mar 07 11:23:13 EST 2013 | orlando216
Yes I can move x2 axis, and check the world/zero with pulses, and it does not lose the pulses.
Electronics Forum | Thu Apr 18 14:04:11 EDT 2013 | dilogic
Are you trying to bring up to life an old machine or the problem just started to appear? There might be several causes for this problem. As a quick fix, you can change in th settings logic polarity of that signal, so it will be OK when actually not.
Electronics Forum | Fri Jul 19 13:50:29 EDT 2013 | kdc45
Thanks for the link, however, I have this manual already and it only shows how to replace motors, belts and prox switches and to adjust for zero set. Appreciate your time and efforts. I did find that it is an OC alarm. Thanks again. Regards, kdc45
Electronics Forum | Tue Feb 11 00:21:54 EST 2014 | bren
I suddenly encountered this error F-AXIS-C/9 Error says Axis has unstable zero point. Any advise?
Electronics Forum | Thu Oct 16 13:25:04 EDT 2014 | tombstonesmt
Evtimov, I agree. I'm leaning more towards the quality of worker rather than software, etc. Since this post this incident happened AGAIN! This time there was ZERO verification performed at start up.
Electronics Forum | Thu Jul 09 15:17:48 EDT 2015 | goodting
Thanks for the inquiry. We used MCD (Motion Control Dia) tool to verify if that is caused by VRM board. No respond(I means the related axis was off) was detected. we swapped that board to other machine, the VRM card was good.... X axis was stopped, t
Electronics Forum | Tue Mar 22 22:42:18 EDT 2016 | ttheis
Apparently the machine is now completing initialization but when attempting to zero axis' it has a time-out waiting to change modes. Machine status page shows an error reading "initialization failure for motion control board."
