Electronics Forum | Fri Sep 14 19:55:06 EDT 2018 | amartineck
I have a GSM1 that when try to zero it, it stops with the "Timeout waiting for spindle up" message. To get thsi up and running, I have set all my machine settings to default and had to reselect the head from a C4 1 head to the flex head. I initially
Electronics Forum | Fri Oct 23 10:21:45 EDT 2015 | kurtiss
During production the machine Cycle Alarm ESC 3. When cycling power the error shows up again during a zero set after performing the Z1 zero set. When it errors out on zero set the only option that the machine allows is to power off. Thanks in advance
Electronics Forum | Tue Nov 08 16:21:37 EST 2011 | nevercry14
Cannot zero set machine actuator problem need help.
Electronics Forum | Tue Nov 15 12:46:15 EST 2011 | cyber_wolf
Seems odd that the machine would zero set if there was a sensor not being made.
Electronics Forum | Fri Sep 06 16:48:01 EDT 2019 | linux
Change SCU card with next module, reboot. Zero set Send proper
Electronics Forum | Mon Jun 19 10:10:18 EDT 2006 | rmitchell
Hi, Our CP6-5 has a Z overflow error when trying to zero set. The table moves in X and Y and almost zeros prior to the Z overflow. Servo Amp? Rob
Electronics Forum | Fri Sep 14 13:00:28 EDT 2012 | mark25y2001
Try to check encoder if properly locked, also check encoder connector if properley inserted, if all good, it's possible that the conveyor controller or encoder problem... to check controller related just try to set in zero value, then if conveyor are
Electronics Forum | Fri Dec 21 09:40:40 EST 2018 | kdexter0928
I am at wits end with this machine. The MTU on my IP2 will not zero set. It gives me a few different errors depending on its mood. I receive MTU T- OT, MTU X- OT, or MTU Y- OT. when the machine attempts to zero set it travels until it OTs. I have tri
Electronics Forum | Tue Nov 15 22:08:58 EST 2011 | nevercry14
Thats the odd part that i can zero set no problem just when i try to run idle the sz sensor ok when goes down but when it goes back up its not bieng retracted up so sensor stays off n eror acurs again any ideas.
Electronics Forum | Fri Jul 19 13:50:29 EDT 2013 | kdc45
Thanks for the link, however, I have this manual already and it only shows how to replace motors, belts and prox switches and to adjust for zero set. Appreciate your time and efforts. I did find that it is an OC alarm. Thanks again. Regards, kdc45
.gif)
