Electronics Forum | Fri Sep 14 19:55:06 EDT 2018 | amartineck
I have a GSM1 that when try to zero it, it stops with the "Timeout waiting for spindle up" message. To get thsi up and running, I have set all my machine settings to default and had to reselect the head from a C4 1 head to the flex head. I initially
Electronics Forum | Fri Dec 21 09:40:40 EST 2018 | kdexter0928
I am at wits end with this machine. The MTU on my IP2 will not zero set. It gives me a few different errors depending on its mood. I receive MTU T- OT, MTU X- OT, or MTU Y- OT. when the machine attempts to zero set it travels until it OTs. I have tri
Electronics Forum | Thu Sep 23 18:56:42 EDT 2010 | slwolbert
Greetings all: I may have a simpler issue going on with this Fuji IP2 machine I'm struggling with. IP2 will boot and zero set, but if production is to be done, during the nozzle check sequence it gives a check nozzle message. This is due to the no
Electronics Forum | Tue Jun 20 19:12:41 EDT 2023 | madisreivik
Hello all ! FUJI IP3 starts up, makes zero setting OK But if I start AUTO mode, it gives error -------------------------------------------------------------------------------- Code 11082010 UsedBy MTU3,MTU4,MTU5 Display Usable Proper Data has
Electronics Forum | Sun Nov 28 21:10:11 EST 1999 | Doug
Larry, To zero the IP3, you hold down the "-" key and press "F5" (set), then F6 to go back to page zero, then sero the machine. On the CP6 you hold down the "-" key and press F6. Doug L.
Electronics Forum | Tue Nov 15 12:46:15 EST 2011 | cyber_wolf
Seems odd that the machine would zero set if there was a sensor not being made.
Electronics Forum | Fri Oct 15 16:52:52 EDT 2010 | wingding
Fuji IP2: I am having problems with an MTU Cycle Alarm error. There is no such error listed in the IP2 manual or the MTU manual. It sometimes comes up while placing parts on a board or sometimes right after Zero Set. Does anyone know what generates t
Electronics Forum | Wed Jul 07 11:40:32 EDT 2010 | daxman
Huh... Can you maybe explain a bit more? Are you getting this error on the IP3 monitor or on the programming computer? Do you use MCS, Fuji Cam or Flexa? Will the machine start up and zero-set? At which point of the power-up does the error arise? Are
Electronics Forum | Mon Dec 19 20:48:26 EST 2005 | Bert
Steve, Thanks for the response. We finally figured out the problem - the speed was set to zero in the proper - duuhhh. All works OK now. Cheers, Bert
Electronics Forum | Tue Nov 15 22:08:58 EST 2011 | nevercry14
Thats the odd part that i can zero set no problem just when i try to run idle the sz sensor ok when goes down but when it goes back up its not bieng retracted up so sensor stays off n eror acurs again any ideas.
.gif)
.gif)
.png)
winsouce.jpg)