Electronics Forum | Fri Apr 10 12:23:27 EDT 2015 | utosun
The recommended wash concentration for stencil cleaning with VIGON SC200 is 25% and this should be confirmed using the ZESTRON BA-20 bath analysis kit. Additional cleaning recommendations are: Wash temperature should be approximately 25 degrees C. /
Electronics Forum | Thu Jun 07 08:55:01 EDT 2007 | grics
Well... Some are worse than others... How can you identify that it is caused by uncured mask and not flux residues? The flux is from indium, 3592. Some research in their tech library revealed that either Kyzen or Zestron would work, which is the re
Electronics Forum | Mon Aug 11 05:26:55 EDT 2008 | gersla
Hi All We are looking for not expensive solution for misprint PCB cleaning for both one and double side assemblies. We have tried different ways and cleaning solutions like: IPA, Vigon Zestron SD300, Vigon SC200 by deep the boards in to stainless ste
Electronics Forum | Wed Mar 24 21:51:23 EST 2004 | davef
Dreamy It sounds like you are having fun in your new job. Saponifier. Alkaline chemicals, added to water, that convert rosin/resin flux residues in the water to soluble soaps. Generally, saponifiers are better if used in an aggressive spray-in-ai
Electronics Forum | Thu Jul 22 16:36:06 EDT 1999 | Mike Konrad
Scott is right, Alpha' 2110 is a good saponifier (be careful though as it can dull your leads). Saponifiers in general are better if used in an aggressive spray-in-air system. Low agitation immersion systems (heated baths or refurbished vapor degre
| 1 |
winsouce.jpg)
