Electronics Forum | Thu Mar 02 23:09:20 EST 2006 | kmp
If you have a servo or encoder problem you should be getting alot of errors. Are all feet leveled on a stable floor? It wouldn't take much to shake them. A full coke machine weighs more.
Electronics Forum | Sat Mar 04 11:07:21 EST 2006 | charls
hi pavel, If you are getting vibrate during fast mode, encoder or motor cable might be faulty. yes i faced the same problem in Juki KE2010 m/c. Try by replacing encoder & motor cable from Motor to driver unit. All the best
Electronics Forum | Thu Mar 02 05:07:51 EST 2006 | pavel
We have bought an old zevatech 730 in Bosch auction (hello MikeZIG). There seems to be something wrong with the X axis servo, the machine is vibrating when the head is moving fast (in fact the machine is dancing, in the race with washing machine it w
Electronics Forum | Wed Mar 08 08:37:24 EST 2006 | wbartley
Pavel First off I agree with Newton It sounds like the machine may not be level. Check all four feet while the machine is warming up none of them should be moving up or down. Chances are your right front or left rear foot is not at the right height.
Electronics Forum | Sat Aug 26 03:12:27 EDT 2017 | ausplex
Hi, We have a Juki KE-730, and was looking to buy a Zevatech KE-730 has a backup and for spares. We thought these machines would be identical, however when we looked at the circuit cards we noticed the image processing cards were quite different. I
Electronics Forum | Fri Aug 20 18:52:40 EDT 1999 | Gary Kemp
Would like to find out if the nozzles used with the Zevatech FS730 and FM740 component placers are repairable. In other words, is there a way to get around having to cough up $500.00 per nozzle when one gets damaged? Any insight would be greatly ap
Electronics Forum | Fri Aug 17 10:18:47 EDT 2018 | charliedci
This might help. See attached:
Electronics Forum | Tue May 07 22:41:32 EDT 2019 | pcbindex1
PCBs applied in vehicles are the fastest growing sub-industry
Electronics Forum | Wed Mar 22 03:00:09 EST 2006 | meritajs
Hi All, We have problem with Zevatech FS-730 This machine shows error E202062: "System error: T axis of head: Parameter error when T axis performs PTP action.(Kind of unit)" and it stop running. It does not pick up components. At low speed it works s
Electronics Forum | Fri Jan 19 07:21:07 EST 2007 | meritajs
Thank all for your advices. But we had sistem error,which was connected,how we could undestand with failure main PC controller boards.We had swoped winchester memory block and Zevatech operation was restored Best regards Peter
.gif)
