Electronics Forum | Thu Dec 13 05:58:05 EST 2018 | ccarterr
Hello, I have re4ecently been tasked with maintaining/repairing several Juki 750-760 SMT machines. Are there any online resources or training available that would help me in my endeavors?
Electronics Forum | Sat Mar 04 11:07:21 EST 2006 | charls
hi pavel, If you are getting vibrate during fast mode, encoder or motor cable might be faulty. yes i faced the same problem in Juki KE2010 m/c. Try by replacing encoder & motor cable from Motor to driver unit. All the best
Electronics Forum | Wed Mar 08 08:37:24 EST 2006 | wbartley
Pavel First off I agree with Newton It sounds like the machine may not be level. Check all four feet while the machine is warming up none of them should be moving up or down. Chances are your right front or left rear foot is not at the right height.
Electronics Forum | Thu Mar 02 05:07:51 EST 2006 | pavel
We have bought an old zevatech 730 in Bosch auction (hello MikeZIG). There seems to be something wrong with the X axis servo, the machine is vibrating when the head is moving fast (in fact the machine is dancing, in the race with washing machine it w
Electronics Forum | Thu Jan 05 14:54:43 EST 2006 | John S.
Cannot speak to the 760, but we've been running 3 750's for seven years now. Never needed to call a service technician in. Juki is our benchmark for customer service. We run approximately 20 hrs per day 5 days a week. John S.
Electronics Forum | Thu Jan 05 14:00:40 EST 2006 | Steve
We are currently runing a JUKI 750 and 760 as well as a 2060. I can't say enough good things about the quality of the machines and service from JUKI. I've had zero downtime in the last 2 years due to mechanical breakdown and our machines run 18 hours
Electronics Forum | Thu Mar 30 08:04:56 EDT 2023 | hub
Hello, I'm looking for zevatech (juki) 570 owner that could help me to resolve my problem. I had the following error that occure just before (or sometime a few after) homing the machine : "E7018:Driver Error KNOCK position error ". Previsously I had
Electronics Forum | Wed Nov 25 08:23:47 EST 2015 | tercel
Does anyone know how to use the Juki 740 / 750 / 760 in Bypass mode, if the Machine has no parts to place? We use 3 Jukis and for some PCBs it is not neccessary to use all 3 of them. so it would be usefull to use the machine in bypass mode. Is it pos
Electronics Forum | Fri Nov 27 04:24:43 EST 2015 | leeg
Hi Tercel, if you goto Maintenance on the main screen and select Idle this will enable boards to pass through.
Electronics Forum | Fri Aug 30 16:22:45 EDT 2019 | valentink
Hello Can somebody provide service / maintenance manual from Juki KE-750 (Zevatech FS-750)? Thanks a lot, Valentin