| http://www.thebranfordgroup.com/dnn3/Auction/AKOR0223.aspx
the foregoing must be in form, scope and substance acceptable to TBG. Credit cards are accepted for payment, Electronic bidding registration and for Liquidated Damages in the event of a default. If paying by credit card, the exchange rate for sales
| http://www.thebranfordgroup.com/dnn3/Auction/NVXS0423.aspx
"). All payments must be in cash, cashier's or certified check, federal wire transfer of immediately available funds or a corporate check accompanied with a bank letter of guarantee, and all of the foregoing must be in form, scope and substance acceptable
| http://www.thebranfordgroup.com/dnn3/Auction/DZSG0222.aspx
shall be in default without a warning letter being required. During the default in payment, the claim shall bear interest at a rate of 9 percentage points above the respective base interest rate. 5.2 If the Contractual Partner is in default with payment
| http://www.thebranfordgroup.com/DNN3/Auction/DZSG0222.aspx
shall be in default without a warning letter being required. During the default in payment, the claim shall bear interest at a rate of 9 percentage points above the respective base interest rate. 5.2 If the Contractual Partner is in default with payment
Surface Mount Technology Association (SMTA) | https://www.smta.org/expos/
volume. The rate of new technology adoption is increasing through developing ever smaller packages with finer lead spacing and substrates with finer lines and spaces. However, design methods, industry standards, materials and manufacturing processes
| https://www.eptac.com/category/upcoming-webinars/shown.bs.collapse/page/4/gtm.start/page/5/gtm.start/__/ais-highlight__/%3C/em%3E/-27.7%25/__/ais-highlight__/page/6/
), are advancing at accelerated rate. This HDI concern will threaten the correct implementation of the prior two bullets of producibility and performance
Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2018/07/pan_APEX06.pdf
). For SnAgCu reflow soldering, a commonly accepted minimum peak temperature of 230°C is necessary to achieve acceptable solder joints
Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2022/04/pan_APEX06-1.pdf
). For SnAgCu reflow soldering, a commonly accepted minimum peak temperature of 230°C is necessary to achieve acceptable solder joints
GPD Global | https://www.gpd-global.com/co_website/pdf/lead-former/CF9-User-Guide-901-1-07.pdf
forming of the component leads and/or machine failure could result. Requirements • The component reel tape must be sturdy enough to maintain adequate component pitch to prevent improper component feeding. If tape integrity is acceptable, the component body
GPD Global | https://www.gpd-global.com/pdf/lead-former/CF9-User-Guide-901-1-07.pdf
forming of the component leads and/or machine failure could result. Requirements • The component reel tape must be sturdy enough to maintain adequate component pitch to prevent improper component feeding. If tape integrity is acceptable, the component body
