| https://www.eptac.com/wp-content/uploads/2021/11/eptac_08_17_16.pdf
| https://www.eptac.com/faqs/ask-helena-leo/ask/soldering-covers-to-a-housing
. As for the flux, the RMA flux is in fact a no clean flux as the activators are bound within the rosin material. The issue is the polymerization of the rosin and the time it takes to fully polymerize and hardened, but in any case the issue to defend your position is IPC-610, Section 10.6.1 on page 10-38
| https://www.eptac.com/soldertips/issues-of-burnt-flux-on-class-3-pcb-assemblies/
. The low solid content fluxes are designed to have the activators in the flux volatilize off during the soldering operation and the residues left behind are benign, which is they
| https://www.eptac.com/ask/soldering-covers-to-a-housing/
. As for the flux, the RMA flux is in fact a no clean flux as the activators are bound within the rosin material. The issue is the polymerization of the rosin and the time it takes to fully polymerize and hardened, but in any case the issue to defend your position is IPC-610, Section 10.6.1 on page 10-38
| https://www.eptac.com/faqs/ask-helena-leo/ask/soldering-aluminum-wire
. You need an aggressive flux, a high activity flux with activators, such as an ORH1 flux. This flux is very active and cleaning is a must to removed the residual fluxes left behind after the solder joint is created, and in your case, after the shield is soldered
| https://www.eptac.com/ask/soldering-aluminum-wire/
. You need an aggressive flux, a high activity flux with activators, such as an ORH1 flux. This flux is very active and cleaning is a must to removed the residual fluxes left behind after the solder joint is created, and in your case, after the shield is soldered
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/efd/applications/coating-fluid?con=t&page=3
, reagents, marking inks, and adhesive activators. Medical Manufacturing: Improve Filling Control Nordson EFD 29 September 2020 Uncover filling methods for better process control in the medical industry. First
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/efd/products/valves/mini-spray-valve
% smaller form factor than conventional spray valves High transfer efficiency with no overspray Modular design for lower cost of ownership Compatible Fluids Activators Coatings Light greases Oils Inks
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/efd/products/valves/radial-spray-valves-782ra-series
. Features Adjustable nozzle air High transfer efficiency Self-adjusting PTFE packings No mist or overspray Cycle rate exceeds 400 cycles per minute Compatible Fluids Accelerators Activators Lubricants
| https://www.eptac.com/faqs/ask-helena-leo/ask/excess-flux-causing-intermittent-connection-issues
; your condition is a defect condition and needs to be rejected and dispositioned. Why did this happen? Low-solid content flux is designed so the activators volatilize off when exposed to soldering temperatures, which in this case are either at the wave soldering system or the soldering iron
