| https://www.eptac.com/ask/what-is-the-correct-way-to-fill-solder-cups/
: I noticed a lot of my techs, while soldering cups, are not putting the soldering iron on the back of the cup, filling with solder, then adding the tinned wire
| https://www.eptac.com/faqs/ask-helena-leo/ask/what-is-the-correct-way-to-fill-solder-cups
: I noticed a lot of my techs, while soldering cups, are not putting the soldering iron on the back of the cup, filling with solder, then adding the tinned wire
| https://www.eptac.com/faqs/ask-helena-leo/ask/solder-tip-flooding-to-remove-leaded-solder
: Is it true we can use lead-free solder to remove leaded solder on our soldering iron tips? I seem to remember we were shown how to flood the tip with lead-free solder three times, wiping clean after each flooding, to remove any lead... Question
| https://www.eptac.com/wp-content/uploads/2013/01/eptac_01_23_13.pdf
| https://www.eptac.com/soldertip/soldertip-47-how-long-does-it-take-to-make-a-solder-joint/
: A solder joint is a metallurgical process; to make a sound solder joint there has to More SolderTips SolderTip #36: Wave Soldering Insufficient Fill and Voids in PTH SolderTip #37
| https://www.eptac.com/faqs/ask-helena-leo/ask/wet-sponge-cleaning-vs-dry-brass-sponge-cleaning
” solder tip cleaning mandatory for leaded and RoHs soldering? Are there any downfalls to only using the dry “copper sponges”? Answer: Cleaning solder iron tips with wet or moist sponges has been the technique used by industry for many years
| https://www.eptac.com/the-serious-risks-from-counterfeit-electronic-parts/
. It is the joining process used to fuse different types of metals together by melting solder. Solder is a metal alloy usually constructed of tin and lead and is melted by using a hot iron
| https://www.eptac.com/faqs/soldertips/soldertip/soldertip-47-how-long-does-it-take-to-make-a-solder-joint
”. If you have a wave solder system, take a look at how long the board is in the wave during the soldering process. If the contact spot of the board going over the wave is 1 inch and the wave conveyor is set at 5 feet/minute, the board is in the solder for 1 second, which by the way is one of the ways which was
.jpg)
