ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/efd/products/solder-paste?con=t&page=24
Solder Paste and Flux | Soldering Pastes & Products | Nordson EFD Nordson EFD Corporate | Global Directory | Languages Division Only All of Nordson Home Products Accessories
| https://www.eptac.com/faqs/ask-helena-leo/ask/excess-flux-causing-intermittent-connection-issues
. We have made a decision to remove all flux from the hand soldering operation and inspect all finish goods. IPC-A-610 Section 10.4 is very vague about this issue
| https://www.eptac.com/faqs/ask-helena-leo/ask/no-clean-flux-application-and-cleaning
No Clean Flux Application and Cleaning - EPTAC - Train. Work Smarter. Succeed Looking for solder training standards, manuals, kits, and more
| https://www.eptac.com/faqs/ask-helena-leo/ask/wave-solder-machine-flux-system-testing-on-a-budget
don’t have to worry about the specific gravity of the flux as the system is always drawing from a clean supply. If the fluxer is a wave or foam fluxer, then you will have to monitor the specific gravity of the flux or the acidic value of the flux, which will be impacted by the evaporation of the solvents within the flux
| https://www.eptac.com/faqs/ask-helena-leo/ask/ipc-5704-vs-ipc-6012-bare-board-cleanliness-comparison
: I am reviewing IPC-5704, and have a question. When reviewing table 4-1, the chloride limit is 0.75 ug/cm2, which converts to 4.4 ug/in2, however; IPC 6012 still has the board cleanliness limit for sodium chloride as
| https://www.eptac.com/ask/ipc-5704-vs-ipc-6012-bare-board-cleanliness-comparison/
: I am reviewing IPC-5704, and have a question. When reviewing table 4-1, the chloride limit is 0.75 ug/cm2, which converts to 4.4 ug/in2, however; IPC 6012 still has the board cleanliness limit for sodium chloride as
| https://www.eptac.com/webinars/conformal-coating-and-solder-resist/
process does not result in contamination. We will take a look at this concern along with issues you may want to consider if you want to take this a step further and apply conformal coatings to the final assembly
| https://www.eptac.com/webinars/conformal-coating-and-solder-resist
process does not result in contamination. We will take a look at this concern along with issues you may want to consider if you want to take this a step further and apply conformal coatings to the final assembly
| https://www.eptac.com/faqs/ask-helena-leo/ask/soldering-stranded-wire
: There are no restrictions as to the flux to be used to solder wires to PCBA. The restriction comes from the specification IPC/J-STD-001 – Paragraph
