PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/topic1213&OB=DESC.html
? This would be nice to have. I am finding discrepancies between my Altium wizard import of the footprint of what it is supposed to be and what I am actually receiving. Example
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/round-vs-rectangular-pth-calculations_topic672_post2310.html
Posted: 25 Feb 2013 at 9:35am It's because the elements that contribute to the Proportional calculation (Fabrication Allowance, Hole- over-Lead, etc
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic672&OB=ASC.html
: 16 May 2012 Location: San Diego Status: Offline Points: 423 Post Options Post Reply Quote Jeff.M Report Post Thanks(0) Quote Reply Posted: 25 Feb 2013 at 9:35am It's because the elements that contribute to the Proportional calculation
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic1213&OB=ASC.html
? This would be nice to have. I am finding discrepancies between my Altium wizard import of the footprint of what it is supposed to be and what I am actually receiving. Example
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic2573&OB=ASC.html
:15pm I assume there SMT case sizes, where you can get by with one footprint (for all mfr's parts that use that SMT case size)? For example, I plan on having IPC "M" and "N" footprints, for 0603, 0805, 1206, 1210, and larger
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/efd/blog/070120-medical-manufacturing-ways-to-improve-fluid-dispensing-control
. You just need to take a closer look at equipment that may be putting your dispensing process at risk. Nordson EFD Solutions: 782RA radial spray valve From Cotton Swab to Radial Spinner In this example, a clinical consumables company reduced process time by 70
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic1921&OB=DESC.html
. Therefore, regardless of the Terminal Lead Height, the maximum Toe value for Pad size calculation is 0.50 mm. Here is an example of a Gull Wing Terminal Lead and the calculation of the Toe value. Note
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/new-2016-solder-joint-goals_topic1921&OB=DESC_page1.html
. Therefore, regardless of the Terminal Lead Height, the maximum Toe value for Pad size calculation is 0.50 mm. Here is an example of a Gull Wing Terminal Lead and the calculation of the Toe value. Note
PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/nonsymmetric-tolerance-question_topic2352.html
, if, for example, I have a datasheet that says my nominal is 3.2 with a +.20 / - .10, I should just enter a min of 3.1 and max of 3.4 right? That would give me a calculated nominal of
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/nonsymmetric-tolerance-question_topic2352.html
, if, for example, I have a datasheet that says my nominal is 3.2 with a +.20 / - .10, I should just enter a min of 3.1 and max of 3.4 right? That would give me a calculated nominal of
