GPD Global | https://www.gpd-global.com/co_website/pdf/doc/SimpleCoat-Series-Operation-Guide-23100600.pdf
obstacles. Note In order for the gantry to move freely, the system must be in Emergency Stop mode. 10. Verify, and tweak as needed, the machine safety check values: home location, park location, and limit values. CAUTION Failure to successfully enter the
GPD Global | https://www.gpd-global.com/pdf/doc/SimpleCoat-Series-Operation-Guide-23100600.pdf
obstacles. Note In order for the gantry to move freely, the system must be in Emergency Stop mode. 10. Verify, and tweak as needed, the machine safety check values: home location, park location, and limit values. CAUTION Failure to successfully enter the
GPD Global | https://www.gpd-global.com/co_website/pdf/doc/Embedded-IR-Heater-User-Guide-22140091.pdf
a general, unde- fined and unexpected fail- ure 1501 OvertempConditionDetected The OptrisCT underboard temperature sen- sor is reporting an over temp condition This is a hardware limit set on the OptrisCT device itself. 1502 UnderboardTemperature
GPD Global | https://www.gpd-global.com/co_website/pdf/dispense/Dispensing-Systems-and-Pumps-Overview.pdf
ultra small, standard, and high volume configurations. • When configured with the smallest auger (062), the pump can dispense solder paste down to 0.005” (125 µm). This newest auger reaches a new limit of dispensing not previously possible. • Standard
GPD Global | https://www.gpd-global.com/pdf/dispense/Dispensing-Systems-and-Pumps-Overview.pdf
ultra small, standard, and high volume configurations. • When configured with the smallest auger (062), the pump can dispense solder paste down to 0.005” (125 µm). This newest auger reaches a new limit of dispensing not previously possible. • Standard
GPD Global | https://www.gpd-global.com/pdf/doc/Embedded-IR-Heater-User-Guide-22140091.pdf
Error Safety Violation Active 1500 AppError unspecified error This is a general, unde- fined and unexpected fail- ure 1501 OvertempConditionDetected The OptrisCT underboard temperature sen- sor is reporting an over temp condition This is a hardware limit
GPD Global | https://www.gpd-global.com/co_website/pdf/doc/Infrared-Preheat-Module-User-Guide-22140087.pdf
is reporting an over temp condition This is a hardware limit set on the OptrisCT device itself. 1502 UnderboardTemperature- OutOfLimit The OptrisCT underboard temperature sen- sor is reporting a temperature in excess of UnderboardLimitHiHi 1503
GPD Global | https://www.gpd-global.com/pdf/doc/Infrared-Preheat-Module-User-Guide-22140087.pdf
over temp condition This is a hardware limit set on the OptrisCT device itself. 1502 UnderboardTemperature- OutOfLimit The OptrisCT underboard temperature sen- sor is reporting a temperature in excess of UnderboardLimitHiHi 1503 UnderboardSensorHead
GPD Global | https://www.gpd-global.com/co_website/pdf/doc/FLOware-Messages-Reference-Guide-22100026.pdf
. Mount a board an program or moun Purging... Click DONE to Stop This message appears when purging without a time limit. Purge will continue until a button is clicked
GPD Global | https://www.gpd-global.com/pdf/doc/FLOware-Messages-Reference-Guide-22100026.pdf
. Mount a board an program or moun Purging... Click DONE to Stop This message appears when purging without a time limit. Purge will continue until a button is clicked