7 imag results

Partner Websites: imag (Page 1 of 1)

:  Impact functionality  Impact reliability 5 Typical Metal Combinations to be Soldered  Cu to Cu  Cu to Sn/Pb  Pd to Sn/Pb  Au to Sn/Pb  Ag to Ag  Sn to Ni  SS to SS  SAC to Sn/Pb  ImAg to SAC  ImSn to Sn/Pb  ENIG to SAC & SnPb  Etc. 6 Flux Selection Process

| https://www.eptac.com/wp-content/uploads/2007/10/webinar_eptac_10_17_07.pdf

:  Impact functionality  Impact reliability 5 Typical Metal Combinations to be Soldered  Cu to Cu  Cu to Sn/Pb  Pd to Sn/Pb  Au to Sn/Pb  Ag to Ag  Sn to Ni  SS to SS  SAC to Sn/Pb  ImAg to SAC  ImSn to Sn/Pb  ENIG to SAC & SnPb  Etc. 6 Flux Selection Process

| https://www.eptac.com/wp-content/uploads/2021/11/webinar_eptac_10_17_07.pdf

.  Board finishes were HASL and ImAg Reliability of Mixed Solder Interconnects – Case Studies, Adam R. Zbrzenzny, Polina Snugovsky, Tanya Lindsay, Ross Lau, Celestica Inc

| https://www.eptac.com/wp-content/uploads/2021/11/webinar_eptac_12_17_08.pdf

Surface Mount International

Surface Mount Technology Association (SMTA) | https://www.smta.org/icsr/speaker_forms/Paper-Format-Requirements.doc

. An IPC investigation is currently underway to develop test methods to better predict sulfur based corrosive environments, while silver manufacturers are actively working to improve their ImAg surface finishes

Surface Mount Technology Association (SMTA)

Webinars and Webtorials

Surface Mount Technology Association (SMTA) | https://www.smta.org/education/presentations/presentations.cfm

. Three surface finishes including OSP, ImAg, and ENIG are considered. The test vehicle consists of 15mm and 6mm Ball Grid Array (BGA) components. The assembled test boards were isothermally aged at 125oC for 12 months, which are then thermally cycled between -40oC to

Surface Mount Technology Association (SMTA)