762 measure moisture content results

What You Must Know About Moisture Sensitive Devices (MSDs)

Imagineering, Inc. | https://www.pcbnet.com/blog/everything-you-need-to-know-about-moisture-sensitive-devices-msds/

What You Must Know About Moisture Sensitive Devices (MSDs) Skip to main content Resources Support Contact Us FAQs Live Chat My Account 847-806-0003 Menu PCB Capabilities Fabrication Technology Roadmap Materials Available HDI Tolerances Certifications

Imagineering, Inc.

Moisture Effects in Common Solderable RF Connector Dielectrics Part II: Characterization of Damage T

Surface Mount Technology Association (SMTA) | https://www.smta.org/knowledge/proceedings_abstract.cfm?PROC_ID=5101

solderable surface mount device connectors. The previous work presented estimates for floor life (as defined in IPC/JEDEC J-STD-033) based on conservatively assumed maximum moisture content thresholds below which these materials should readily survive the solder reflow process

Surface Mount Technology Association (SMTA)

. 6 What Causes Delamination  Thermal shock  Wave solder process  Manual soldering  Rework and Repair process  Moisture in the board

| https://www.eptac.com/wp-content/uploads/2021/11/webinar_eptac_11_19_08.pdf

10.6.1 Cleanliness flux Residues 7 Question #3 •  Flux residues are flux residues, regardless of whether they are burnt or not. •  The low solid content fluxes are designed to have the activators in the flux volatize off during the soldering operation and the residues left behind are benign

| https://www.eptac.com/wp-content/uploads/2016/08/eptac_08_17_16.pdf

10.6.1 Cleanliness flux Residues 7 Question #3 •  Flux residues are flux residues, regardless of whether they are burnt or not. •  The low solid content fluxes are designed to have the activators in the flux volatize off during the soldering operation and the residues left behind are benign

| https://www.eptac.com/wp-content/uploads/2021/11/eptac_08_17_16.pdf

.  Easy to work with for component removal. HumiSeal Technical Bulletin 1B31 Aerosol 6 Epoxy  Epoxies are very hard, usually opaque, and good at resisting the effects of moisture

| https://www.eptac.com/wp-content/uploads/2007/11/webinar_eptac_11_14_07.pdf

• reliable 14 Key Psychometric Components for a Certification Program - Validity • What is meant by test validity? ! Does the test measure what it is supposed to measure

| https://www.eptac.com/wp-content/uploads/2016/11/eptac_12_14_16.pdf

21 EWS Delamination vs Measles.PPT

| https://www.eptac.com/wp-content/uploads/2021/11/webinar_eptac_09_16_09.pdf

. That is, either the environmental stress was higher than expected or the material strength was lower than expected. Pb-Free Reflow, PCB Degradation and Moisture Absorption Monday, July 20, 2009 | Kerin

Components, Challenges, and the Role of Quality Standards in Cable Harness Assembly

| https://www.eptac.com/blog/quality-standards-in-cable-harness-assembly-quality-control-measure

. Environmental Factors: Cable harnesses may be exposed to various environmental conditions such as moisture, temperature fluctuations, and chemical exposures

HELLER INDUSTRIES 1700

Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2018/07/wpload.pdf

. To demonstrate the repeatability of the process conditions, specific tests were conducted to measure the performance of the Heller Oven under several process loading conditions

Heller Industries Inc.